eurowise MK1 Shifter Box Adapter Bracket Installation Guide
- May 15, 2024
- eurowise
Table of Contents
MK1 shifter box adapter bracket
(o2a / 02j) styles
MK1 Shifter Box Adapter Bracket
The O2a shifter box is mounted from the bottom of the car. Route the shifter cables over the top of the steering rack. You can cut off the OEM mounting brackets for the linkage shifter if desired, It will allow more clearance for the downpipe and cables.
The O2j shifter box is mounted from the bottom of the car. Route the shifter
cables over the top of the steering rack. You can cut off the OEM mounting
brackets for the linkage shifter if desired, It will allow more clearance for
the downpipe and cables.
Once the bracket on rear is hand tight on the shifter box use a punch or
scribe to mark where the 2 oem studs in the shifter box is touching the body.
Remove shifter box and drill two 3/8 inch holes for the bolts to pass thru the
tunnel. Using the OEM 13mm nuts bolt the front of the shifter box in place and
use 2 M8 bolts to attach the rearward part of the shifter box.
IF YOU HAVE ANY QUESTIONS, COMMENTS, OR CONCERNS RELATED TO YOUR PRODUCT PLEASE CONTACT US!
440 SPRINGBROOK ROAD. CHARLOTTE, NC 28217
704-559-8100
INFO@EUROWISE.COM
WWW.EUROWISE.COM
SHOP.EUROWISE.COM
References
- Specializing in European Service, Performance and Fabrication – Eurowise Performance
- Eurowise Audi, BMW, Volkswagen, Mercedes, & Porsche Service
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>