SuperFish 3000 PondClear Filter User Manual
- May 15, 2024
- SuperFish
Table of Contents
SuperFish 3000 PondClear Filter
Specifications
PondClear Filter| Max. pond content| Max. pump capacity| UVC| Voltage| Filter
inlet| Filter outlet| Dimensions| Capacity of the pump| Pump
---|---|---|---|---|---|---|---|---|---
3000| 3,000 l| 1,000 l/h| 5 watt| 220-240 V/50 Hz| 25/32/40 mm| 32 mm|
37x24x24 cm| N/A| N/A
3000 Kit| 3,000 l| 1,000 l/h| 5 watt| 220-240 V/50 Hz| 25/32/40 mm| 32 mm|
37x24x24 cm| 1,000 l/h| 12 watt
6000 Kit| 6,000 l| 5,000 l/h| 7 watt| 220-240 V/50 Hz| 25/32/40 mm| 50 mm|
37x27x40 cm| 3,500 l/h| 14 watt
12000 Kit| 12,000 l| 10,000 l/h| 13 watt| 220-240 V/50 Hz| 25/32/40 mm| 75 mm|
55x38x43 cm| 5,300 l/h| 29 watt
Product Usage Instructions
General Instructions
Read the manual carefully before using the device and keep it for future
reference.
Safety Instructions
Always follow the safety instructions provided to ensure safe use of the
device. Failure to comply may result in risks to individuals or the
environment.
Cleaning and Maintenance:
Regularly clean the filter to prevent blockages and ensure optimal
performance. Replace UV Clear PL-lamps as per the recommended intervals for
effective sterilization.
Installation
- Select a suitable location near the pond for installing the Pond Clear Filter.
- Connect the filter inlet and outlet as per the specifications provided in the manual.
- Ensure proper power supply and voltage compatibility before connecting the device.
Operation
Switch on the Pond Clear Filter and monitor its performance regularly.
Adjust settings as needed for efficient filtration.
Frequently Asked Questions
-
Q: How often should I clean the filter?
A: It is recommended to clean the filter at least once a month to maintain optimal functionality. -
Q: Do I need to replace the UV Clear PL-lamp?
A: Yes, replace the UV Clear PL-lamp according to the specified intervals to ensure proper sterilization of the pond water. -
Q: What should I do in case of a power outage?
A: Wait for power to be restored. Once power is back, ensure the filter is functioning correctly.
Translation of original manual.
SuperFish PondClear Filter 3000 – 3000 Kit – 6000 Kit- 12000 Kit
General instructions
Read this manual carefully before using this device. Keep this manual for future reference.
Use
- Filter with built-in UVC. Suitable for outdoor usage.
- This filter should be only used for cleaning pond water and the water temperature should not exceed 35°C. It should never be used for other liquids or chemicals.
- The UVC device should only be switched on when there is sufficient water flow. Never run the device without water.
- Place the filter in a dry and sheltered place. Not in direct sunlight.
Safety
Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may endanger persons or the environment.
- WARNING! This UVC device emits UV-C radiation, which can cause serious eye damage and/or damage to the skin. The UV lamp must therefore always be installed completely shielded from the eyes.
- Never look at a burning UV lamp. Do not switch on the lamp until it is fully shielded installed and fully submerged.
- This device must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
- Ensure the voltage shown on the label matches the mains supply voltage.
- This device must be connected to a socket which is earthed.
- Protect the socket and plug against moisture. Use a drip loop to ensure that water cannot reach the socket via the cord (see Fig. A).
- Don’t use the product if the device, quartz glass, cord or plug is damaged. Replace the quartz glass or return the device to your dealer for repair or recycling.
- If the power cord or plug is damaged, the electrical part should be replaced.
- Be careful with the combination of water and electricity. Do not operate with wet hands. Dry hands before carrying out maintenance.
- Always switch off all devices in the pond before maintenance. Disconnect the plug(s) from the socket.
- NOTICE! The UV lamp becomes warm. Allow the lamp to cool for at least 10 minutes before carrying out maintenance.
- In the event of frost or the risk of frost, appropriate precautions must be taken to prevent it from freezing.
- This device can be used by children aged from 8 years and above, persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or instructions concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and maintenance of the device shall not be done by children without supervision.
- Modifications to the device may affect the safety. The warranty will also expire.
- Aquadistri is not liable for any problems, damage or accidents due to incorrect use of this device.
Installation
- The filter should be installed next to the pond (minimum distance 50 cm).
- The filter inlet must be higher than the water level in the pond, preventing the filter to overflow.
- Cut the hose connection on the same diameter as the diameter of the hose (B). Unscrew the hose connection from the filter before cutting to prevent damage to the filter.
- Connect the pond pump to the filter inlet, using a pond hose and hose clamps (C-a).
- Put filter outlet above the pond. If needed fit a pipe to lengthen the outlet, the horizontal length of this pipe should not exceed 1 metre to avoid pressure in the outlet. Never block or reduce the outlet, otherwise the filter may overflow and your pond could get empty.
- Install and operate the pump and check the system for leakage, make sure all connections are 100% waterproof. Leakage may lead to an empty pond and cause harm to your fish and plants.
- Check the water level in the filter and make sure it cannot overflow.
- Check monthly if UV lamp is lit through the control window in the cover (C-b).
Maintenance of the filter
- Always disconnect from the mains supply before carrying out any maintenance!
- Clean filter regularly, after first installation. If your pond is heavily polluted, the filter sponges should initially be cleaned daily. Remove the filter sponges and rinse them with clean tap water.
- Depending on the grade of pollution, the filter should be flushed at least once a month with tap water.
- Replace the filter sponges yearly.
- Clean the Bio-Balls in a bucket filled with pond water to maintain bacteria life. Do not use tap water!
- In the winter season, when the system is not used, the TopClear filter should be removed to avoid the risk of freezing.
Maintenance of the UVC-unit
- Check monthly if UV lamp is lit through the control window in the cover (C-b).
- Always disconnect from the mains supply before carrying out any maintenance!
- The UVC device and quartz glass should be cleaned yearly or more often if algae growth increases!
- The lamp is hot, wait 10 minutes after switch off before opening the unit.
- Remove the protective cover of the UVC (D-c), by pulling it loose from the filter cover by the latch (D-d).
- Slide the red switch lock (E-e) to unlock the unit head and housing.
- Turn the unit head counter clockwise against the stop, then carefully pull it out of the housing (E-f).
- Loosen the screw (F-g), remove the locknut (F-h). Remove the quartz glass including the gasket by a slight rotary movement (F-j).
- Clean the quartz glass outer face with SuperFish UVC Pump & Clean carefully and check for damage.
- Remove the UV-lamp together with UV-tube clip (G-k) and tube protection ring (G-l) and remove the O-ring (G-m) from the unit head. Clean the unit head and make sure that it’s dry, place a new O-ring if necessary.
- Replace the UV-lamp if necessary (recycling). Insert the (replacement) UV-lamp with a UV-tube clip and tube protection ring in the fitting of the unit head.
- Insert the quartz glass with the gasket in the unit head, slide the locknut over the quartz glass and tighten it onto the unit head. Place the screw back and tighten the locknut (H).
- Place the unit head with the fitted UV-lamp and quartz glass back into the housing. Turn it clockwise up to the stop and slide the red switch lock to the housing (J).
- Replace the protective cover of the UVC on the filter cover and snap it in place.
- To avoid UVC overheating, unplug the filter from mains when no water is flowing through the filter.
- The UV-lamp should be replaced yearly.
- (PondClear 3000: SuperFish UV Clear PL-lamp 5 watt, G23-105 mm – Art. 06011005)
- (PondClear 6000: SuperFish UV Clear PL-lamp 7 watt, G23-135 mm – Art. 06011010)
- (PondClear 12000: SuperFish UV Clear PL-lamp 13 watt, G23-236 mm SP – Art. 06011023)
Technical specifications
- PondClear Filter 3000 3000 Kit 6000 Kit 12000 Kit
- Max. pond content 3,000 l 3,000 l 6,000 l 12,000 l
- Max. pump capacity 1,000 l/h 1,000 l/h 5,000 l/h 10,000 l/h
- UVC 5 watt 5 watt 7 watt 13 watt
- Voltage 220-240 V/50 Hz 220-240 V/50 Hz 220-240 V/50 Hz 220-240 V/50 Hz
- Filter inlet 25/32/40 25/32/40 mm 25/32/40 mm 25/32/40 mm
- Filter outlet 32 mm 32 mm 50 mm 75 mm
- Dimensions 37x24x24 cm 37x24x24 cm 37x27x40 cm 55x38x43 cm
- Capacity of the pump* N/A 1,000 l/h 3,500 l/h 5,300 l/h
- Pump* N/A 12 watt 14 watt 29 watt
Recycle information
This symbol indicates that this product (if it is discarded) may not be
disposed of with normal household waste.
Instead it must be handed in at an official collection centre (e.g. HWRC). Or
can be returned to the dealer when purchasing a similar new product. Follow
the applicable rules in your country for the separate collection of electrical
and electronic products.
Separate collection and recycling are better for the environment, public
health and reduces waste.
- Date of purchase
- Date
- Dealer stamp
www.aquadistri.com
Vlietweg 8, NL-4791 EZ Klundert The Netherlands,
info@aquadistri.com