SuperFish 06090025 Pond Multi Vac Pond Vacuum Cleaner User Manual
- May 15, 2024
- SuperFish
Table of Contents
SuperFish 06090025 Pond Multi-Vac Pond Vacuum Cleaner
Product Information
Specifications
-
Product Name: SuperFish Pond Multi-Vac Pond Vacuum Cleaner
-
Intended Use: Multi-purpose vacuum cleaner for dust, grit,
leaves, sludge, and dirt from pond water -
Design: Suitable for indoor and outdoor use
-
Protection: Protection class II, protected against splashing water
-
Compliance: Complies with all applicable EU standards
-
Usage: Domestic use only, not intended for industrial use
Product Usage Instructions
Safety Instructions
Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may endanger persons or the environment.
Using the Pond Multi-Vac as a Pond Cleaner
To use the SuperFish Pond Multi-Vac as a pond cleaner, follow the instructions provided in the manual.
Using the Pond Multi-Vac as a Vacuum Cleaner
To use the SuperFish Pond Multi-Vac as a vacuum cleaner, install the required dust filter (not included, separate purchase necessary). Do not use the device as a vacuum cleaner without fitting the dust filter. Empty the container regularly.
Maintenance
Proper maintenance is essential for the longevity of the product. Refer to the manual for maintenance instructions.
Recycling
When disposing of the product, do not dispose of it with normal household waste. Follow the recycling guidelines in your country for electrical and electronic products.
Warranty
The SuperFish Pond Multi-Vac comes with a warranty. Refer to the warranty information provided for details.
FAQ
- Q: Can I use the Pond Multi-Vac for industrial purposes?
- A: No, the Pond Multi-Vac is designed for domestic use only and should not be used for industrial purposes.
- Q: Do I need to purchase a dust filter separately for using the device as a vacuum cleaner?
- A: Yes, a dust filter is required to use the Pond Multi-Vac as a vacuum cleaner. It is not included and must be purchased separately.
General instructions
Read this manual carefully before using this device. Keep this manual for future reference.
Meaning of symbols
The following warning symbols and/or signal words are used in this manual:
-
DANGER!
This means an imminent danger due to electric current. Failure to follow the safety instructions can result in serious or fatal injury and/or serious damage to the product or environment. -
WARNING!
This means a dangerous situation. Failure to follow the safety instructions can result in moderate or minor personal injury and/or damage to the product or environment. -
NOTICE!
This means caution, useful information or advice.
Fig… This refers to the relevant drawing … on pages 2 and 3 of this manual.
Meaning of the symbols on the device itself:
- This device has protection class II.
- This device is protected against splashing water.
- This device complies with all applicable EU standards.
- This device may not be disposed of with normal household waste but must be collected separately for recycling.
Use
Suitable for indoor and outdoor use, to be used as a multi-purpose vacuum cleaner for dust, grit, leaves, sludge and dirt from pond water. This device is designed for domestic use and is not intended for industrial use.
- Certain substances may form explosive vapours or mixtures when set in motion by the suction air. Therefore, never vacuum up the following substances: flammable, corrosive and/or explosive gases, liquids or dust particles (reactive dust particles, reactive metal dust particles such as aluminium, magnesium or zinc, strong alkaline or acidic cleaning agents, undiluted strong acids or alkalis, solvents, petroleum, petrol, paint thinner, acetone, etc).
- Do not use for sucking up salt water, fats, oils or foodstuffs.
- Do not use for vacuuming very fine dust such as ash, soot, plaster and cement: these substances cannot be captured by the dust filter.
- Do not use to vacuum up toxic or carcinogenic substances such as asbestos, asbestos dust, etc.
- Never vacuum up burning or glowing objects such as cigarettes, cigarette butts, charcoal and/or briquettes, etc
Safety
Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may endanger persons or the environment.
-
This device must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
-
Ensure the voltage shown on the label matches the mains supply voltage.
-
This device must be connected to a socket which is earthed. Fig. A Protect the socket and plug against moisture. Use a drip loop to ensure water cannot reach the socket via the cord.
-
Don’t use the product if the device, cord or plug is damaged. Return the device to your dealer for repair or recycling. A damaged cord or plug must be replaced immediately by an authorised service/electrician.
-
Be careful with the combination of water and electricity. Do not operate with wet hands. Dry hands before carrying out maintenance.
-
Never use the device when there are people in the water.
-
Always switch off the device before maintenance. Remove the plug from the socket.
-
Prevent the device from falling into the water. Do not use the device again in case of water damage. The Warranty expires in the event of improper use or water damage.
-
If foam forms or liquid escapes, switch device off immediately and remove plug from wall socket.
-
Do not lift or move the device by its cord or suction hose, only lift it by the handle. Fig. B The device must be placed, at least 2 metres away from the pond, on a horizontal flat surface to prevent it from tipping over.
-
Use the device only with the original filter sponge (pond cleaning) or original dust filter (vacuuming).
-
This device can be used by children aged 8 years and above, persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or instructions concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and maintenance of the device shall not be done by children without supervision.
-
Modifications to the device may affect the safety. The warranty will also expire.
Function
A multi-functional pond vacuum cleaner with two modes, one for vacuuming and one for pond cleaning. Constant suction is used for vacuuming dirt around the house and in the garden. This requires a dust filter (Art. 06090030), which is not included. For removing sludge and dirt from the pond, an interval suction is used, the dirt is vacuumed up together with the pond water (is also a water change). The water drains away via the discharge hose, which you can use to water the plants. The sludge, which you can use as organic fertiliser, is collected in the dirt collection bag.
Using the Pond Multi-Vac as a pond cleaner
Fig. C To use the SuperFish Pond Multi-Vac as a pond cleaner, install the following accessories.
- Remove the motor housing (top) by opening both clamps (c) and lifting the motor housing from the container.
- Check that the filter sponge (a) is around the lower part of the motor housing. If this is not the case, insert the filter sponge (a) around the lower part of the motor housing and secure it with the elastic band.
- Place the motor housing (b) on the container and secure it with the two clamps (c).
- The discharge hose has one end with a rubber shut-off valve and one open end. Insert the open end of the discharge hose (d) into the outlet of the container (bottom/rear).
- Put the dirt collection bag (i) around the other end (with shut-off valve) of the discharge hose.
- Insert the suction hose (e), with the little catch pointing upwards, into the inlet of the container and turn it a quarter turn so that it locks in place.
- Insert the handle of the suction hose (f) into a suction tube. Insert the suction tubes together to the desired length (42/78/114/150 cm).
- Insert the suction tube into the transparent nozzle (g)
- Plug into the mains socket.
- You can now take the Pond Multi-Vac into operation by pressing the tilt switch (h) to position II.
- The Pond Multi-Vac will now start suctioning. Every time the container is full of water, it will automatically turn off to allow the dirty water to drain away via the drain hose and then start to suction again (Interval).
NOTICE! Always drain the dirty water from the container after use, the container is not intended for storing liquids.
Using the Pond Multi-Vac as a vacuum cleaner
Fig. D To use the SuperFish Pond Multi-Vac as a vacuum cleaner, install the
following accessories.
NOTICE! To use the Pond Multi-Vac as a vacuum cleaner, you will need a dust
filter (o) (Art. 06090030 – SuperFish
Pond Multi-Vac Dust Filter), this is not supplied as standard and should be
purchased separately. Do not use the
Pond Multi-Vac as a vacuum cleaner without fitting the dust filter.
- Remove the motor housing (top) by opening both clamps (c) and lifting the motor housing from the container.
- First place the dust filter (o) in the container, with the top edge of the dust filter completely sealing the container.
- Place the motor housing (b) on the container and secure it with the two clamps (c).
- Insert the sealing cap (d) into the outlet of the container (bottom/rear).
- Insert the suction hose (e), with the little catch pointing upwards, into the inlet of the container and turn it a quarter turn so that it locks in place.
- Insert the handle of the suction hose (f) into a suction tube. Insert the suction tubes together to the desired length (42/78/114/150 cm).
- Insert the suction tube into the transparent nozzle (g)
- Plug into the mains socket.
- You can now take the Pond Multi-Vac into operation by pressing the tilt switch (h) to position I.
- The Pond Multi-Vac will now start vacuuming constantly.
NOTICE! Empty the container regularly
Maintenance
NOTICE! The Pond Multi-Vac must be cleaned regularly for trouble-free operation. Faults due to a dirty motor caused by improper or lack of maintenance are not covered by the warranty.
- ALWAYS disconnect the mains plug before carrying out maintenance!
- Clean the housing regularly with a damp cloth (preferably after each use).
- For stubborn dirt, use a soft cloth moistened with warm soapy water. NEVER use solvents (benzene, alcohol, ammonia, etc.), these can damage the plastic parts.
- Loosen the clamps and remove the motor housing (b) from the container.
- Carefully remove the filter sponge (after pond cleaning) from the motor housing and rinse it clean.
- Let the filter sponge dry thoroughly before replacing it. Replace the filter sponge if it is damaged.
- Clean the underside of the motor housing and the float with a soft cloth, check for any damage and that the float is still working properly.
- You can rinse out the dirt collection bag with water.
- If the Pond Multi-Vac has been used as a vacuum cleaner, remove the dust filter after use and shake it out to maintain vacuum power.
- The dust filter can be rinsed with water, let it dry well before replacing it. Replace the dust filter (Art. 06090030) if it is damaged.
- Empty the container and clean it on the inside with a (damp) cloth and/or rinse it with water. Make sure the container is dry before replacing the motor housing.
NOTICE! Always store the device in a dry place after use.
Recycling
This symbol indicates that this product (if it is discarded) may not be disposed of with normal household waste. Instead, it must be handed in at an official collection centre (e.g. HWRC). Or can be returned to the dealer when purchasing a similar new product. Follow the applicable rules in your country for the separate collection of electrical and electronic products. Separate collection and recycling are better for the environment, and public health and reduces waste.
Warranty
2-year manufacturer’s warranty on materials and construction defects. Devices must be returned complete with all components, accompanied with an official proof of purchase confirming a purchase date for any warranty claims. Incomplete devices of which parts are missing, and devices without proof of purchase are not eligible for warranty. After receiving and checking, we will determine whether the device will be repaired or replaced. For a device repaired or replaced under warranty, the remaining time of the original warranty period applies. Carefully read the instructions on installation, use and maintenance. Damage due to incorrect use, water damage, damage due to contamination or not cleaning the device, damage to the cord are not covered by the warranty. Always keep the proof of purchase, without proof of purchase the warranty will be void
Technical specifications
- Pump: 220-240 V/50 Hz.
- Size: 52 x Ø 38 cm
- Cord: 3.5 metres
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>