PARMIDA PLED-CNP150W57K-W LED Canopy Light Instruction Manual
- May 15, 2024
- PARMIDA
Table of Contents
PARMIDA PLED-CNP150W57K-W LED Canopy Light
INSTRUCTION MANUAL
PLED-CNP150W57K-W
IMPORTANT: When using electrical equipment, basic safety precautions should always be followed as below:
READ AND FOLLOW BELOW SAFETY INSTRUCTIONS
1. To reduce risk of electric shock, turn off power before installation or
servicing.
2. This luminaire must be installed in accordance with the NEC and local
electrical code. If you are not familiar with these codes and requirements,
consult a qualified electrician.
3. Verify the availability of necessary tools ad incidental materials.
UNPACKING: Thoroughly inspect the fixture for freight damage. Freight damage should be reported to the delivery carrier.
PACKAGE CONTENTS: 1 x 150W Canopy Light, 1 x Safety Rope
COMPATIBLE DIMMERS: Only compatible with 0-10V LED dimmers.
LEVITON: DD710-BNDZ, DS710-10E
LUTRON: DVTV-WH, DVSTV-453P
STEPS FOR INSTALLATION
1. SCREW MOUNTING: Put the fixture on the mounting surface and mark the
locations of the four screw holes. Remove the fixture and drill holes at the
four mounting holes.
2. Using wire nuts (not included), connect the fixture wires to the supply
wires. If using a dimmer, connect the purple (dim+) and pink (dim-) wire to
each of the 0-10V dimmer wires separately. If a dimmer is not being used, both
dimmer wires must NOT be left exposed. Use wire nuts to cover each dimmer wire
independently.
3. Optional: If you choose to use the 30cm safety rope, screw one end of the
safety rope to the fixture and screw the other to the mounting surface using
appropriate mounting hardware (not included).
4. Fixture is best mounted by drilling through the designated holes to secure
fixture to mounting surface using appropriate mounting hardware (not
included). All unused holes must be plugged. Waterproof silicone will ensure a
tight seal.
5. 3/4″ CONDUIT MOUNTING: Follow Step 2 to wire the fixture, and Step 3 if
desired. Then rotate the fixture to screw the threaded pipe end into the
center mounting point on the fixture.
Specifications
-
Product: 150W LED Canopy Light
-
Model: PLED-CNP150W57K-W
-
Compatible Dimmers: Leviton DD710-BNDZ, DS710-10E; Lutron
DVTV-WH, DVSTV-453P -
Power Consumption: 150W
-
Dimming: 0-10V LED dimmers
-
Power Wires: White – Neutral, Black – Line, Green – Ground
-
Dimming Wires: Purple – Dimming+
FAQ
Q: Can I use a different driver with the fixture?
A: No, only use the Parmida Lighting driver included with the fixture to avoid the risk of fire or electric shock.
Q: What tools are needed for installation?
A: You will need a drill, appropriate mounting hardware, wire nuts, and optionally, waterproof silicone for sealing.
WARNING
RISK OF FIRE OR ELECTRIC SHOCK.
DISCONNECT MAIN POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR
SERVICING THE LIGHT. DO NOT USE ANY OTHER DRIVER EXCEPT PARMIDA LIGHTING
DRIVER THAT IS INCLUDED WITH THE FIXTURE.
info@parmida.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>