VAPORESSO XROS PRO Pod Kit User Manual
- May 15, 2024
- VAPORESSO
Table of Contents
VAPORESSO XROS PRO
XROS PRO Pod Kit
Thank you for choosing VAPORESSO product. Please read this instruction
carefully before use to ensure a perfect experience.
If there is any additional requirement about this product, please consult the
local agent or contact us through our website:
www.vaporessocom
ENLARGED VIEW
SPECIFICATION
SPECIFICATIONS | 3m1 Version | 2ML Version (TPD) | 2ML Version |
---|---|---|---|
Dimensions | 119.7024.418.45mm | 115.224.418.45mm | |
Pod Capacity | 3m1 | 2m1 (TPD) | 2m1 |
Resistance: | 0.4f1 | oAn | loniam |
Battery Capacity | 1200mAh | ||
Charging | Type-C, 2A | ||
Display | 0.42″OLED Screen,1 LED Light Indicator, lLock Light Indicator |
USE INSTRUCTIONS
-
Install & Replace the Pod
Pull out the pod from the battery and install the new one.
*If it’s the first time using the device, please tear off the sticker of the preinstalled pod. -
Fill the E-liquid(Refer to FIGURE1)
Snap off the mouthpiece then squeeze the e-liquid through filling hole.
After filling, put the mouthpiece back and make sure it’s shut firmly.
*If it’s the first time filling the e-liquid, please wait 5 minutes for the coil to prime. -
Adjust Airflow(Refer to FIGURE2)
There is an airflow control toggle on the back of the battery. Adjust the toggle according to your vaping habits for different airflow effects. -
Power ON/OFF
Click the power button 5 times in 2 seconds to power on or power off the device. -
Start Vaping
The device is both button-activated and draw-activated. Press the power button or inhale directly through the mouthpiece and exhale to start vaping. The LED indicator will flash in green/blue/red color according to the power status during vaping. -
Check the Battery Level
The LED indicator will stay in green/blue/red color to show the battery level after vaping or inserting the pod.Battery Level| LED Color
---|---
70%~100%| Green
30%~70%| Blue
0~30%| Red -
Charging
Please use the in-box Type-C cable to charge the device. The screen will show charging status in real time, and 100% means fully charged. -
Lock Button(Refer to FIGURE3)
You can lock the power button by flipping the lock button, and the Power ON/OFF function still works. -
Light Effect Settings
Click the power button 2 times in 2 seconds to turn on/off the LED indicator -
Power/Mode Settings
When using the 0.6/0.7/0.8/1.0/1.2Ω PODs, click the power button 3 times in 2s to enter the vaping mode setting interface, then click the power button to choose P (POWER), N (NORMAL) or E (ECO) mode, and wait 3 seconds to save the current status and exit.
*When using the 0.4Ω POD, click the power button 3 times in 2s to enter the power setting interface, and click again to adjust the wattage. -
Puff cleaned Reset
Click the power button 2 times in 2s to enter the puff cleaned reset interface then click the power button to choose YES or NO, and wait 3s to exit.
PROTECTIONS
Low Resistance/Short-circuit/High Temperature: The red indicator will
flash 5 times and the device will stop working.
No Load/High Resistance: The current battery level indicator will flash 5
times and the device will stop working.
Low Voltage/Over Discharging: The red indicator will flash 3 times and
the
CAUTIONS
- Please turn off the device when it is not in use.
- Do not leave the charging device unattended.
- Do not drop, throw or abuse your device, which may cause damage.
- Please use a standard USB output charger with proper charging current and voltage range.
- Keep away from the water or any flammable gas, liquid.
- Do not expose the device to direct sunlight, dust, moisture or mechanical shock.
- Do not expose the device to extreme temperature. (Recommended temperature range: 10~40℃ using and 10~40℃ while storing).
- EEE Recycling: the product should not be treated as household waste, instead, it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
- Battery Recycling: the product battery should not be treated as household waste, instead, it should be handed over to the applicable used battery collection point for recycling.
- Only have your device repaired by VAPORESSO. Do not attempt to repair it by yourself as damage or personal injury may occur. device will stop working.
Over Charging: The green indicator will stay on and the device will stop
charging.
Overtimes(8s): The device will stop working and the LED indicator will
flash in green-blue-red
WARNINGS
This refillable electronic cigarette is intended for use with compatible e-liquid, which may contain nicotine. Nicotine is an addictive substance and it is not suitable or recommended to use in following cases:
-
This device is not suitable for:
– Persons under the legal smoking age.
– Persons experiencing heart disease, stomach or duodenal ulcers, liver or kidney problems, long-term throat disease or difficult breathing due to bronchitis, emphysema or asthma.
– Persons with an overactive thyroid gland or experiencing phaeochromocytoma (a tumour of the adrenal gland that can effect blood pressure).
– Persons taking certain medications like Theophylline, Ropinirole or Clozapine and etc -
This device is not recommended for:
– Non-smokers
– Pregnant or breastfeeding women -
You may experience the following results if you use nicotine containing e-liquid with this product. If it happens, please consult a healthcare professional and show them this leaflet if possible:
Feeling faint / Nausea / Dizziness / Headache / Coughing / Irritation of the mouth or throat / Stomach discomfort / Hiccups / Nasal congestion / Vomition / Chest palpitations / pain or an irregular heart rate.
This device should not be used by persons under the legal smoking age.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>