Blossom TL5014HS Square Bar Table Instruction Manual
- May 15, 2024
- blossom
Table of Contents
30” Square Bar
Table
V 1.0
TL5014HS Square Bar Table
NOTICE
Do not overtighten screws. (Insert all screws before tighten screws.)
- Please do not exceed the weight limitations of this item.
- Do not stand on or use any part of this item as a step ladder.
- Firmly secure all bolts, screws and nuts before use.
- Reconfirm that all bolts, screws, and nuts are secure every 90 days.
- Do not use or store this item in the proximity of open flame or flammable/combustible chemicals.
- Be aware that some parts are heavy and have sharp edges.
- Please adjust the speed slowly when you use electric drill for assembling to avoid screw slippage.
TOOLS REQUIRED
HARDWARE
PARTS
PRODUCT ASSEMBLY-OVERALL VIEW
- Look at following overall view of this table and exact position of each parts to be assembled.
PRODUCT ASSEMBLY
-
Attach part B Table leg Ⅰ to part A Table top with 4 pcs of Hardware 3 Bolt, 5 nut and 6 washer.
Notice: Please put the B Table leg Ⅰto the posit on with “ B Table leg Ⅰ” sticker on Table Top
Do not tighten screws too much at this step.
Attach part C Table leg Ⅱ to part A Table top with 4 pcs of Hardware 4 Bolt, 5 nut and 6 washer.
Attach part D Short rail to part B&C Table leg with 4
pcs of Hardware 1 Bolt in the narrow side of table leg
Do not tighten screws too much at this step.
Attach part D Short rail to part B&C Table leg with 4 pcs of Hardware 2 Bolt in the wide side of table leg
Please pay attention of the narrow side and wide side
on the table leg before installation -
Attach part E Long rail to part B&C Table leg with 4 pcs of Hardware 1 Bolt in the narrow side of table leg.
Do not tighten screws too much at this step. Attach part E Long rail to part B&C Table leg with 4 pcs of Hardware 2 Bolt in the wide side of table leg.
Please pay attention of the narrow side and wide side on the
table leg before installation -
Check and tighten all the bolts and screws again and finish the assembly.
