RSG 2010plus 4Runner Cat Skid Guard Installation Guide

June 8, 2024
RSG

RSG METALWORKS
720.523.3999
2010+ 4Runner Cat Skid Guard Install Notes

2010plus 4Runner Cat Skid Guard

Tools Needed:

  • 14mm ratcheting wrench (Flex head preferred)
  • 12mm socket and ratchet.
  • Allen Key (provided)
  • A friend (to help lift and hold in place)
  1. First, install the smaller plate to the back of the transmission crossmember.
    ○ Use the two provided carriage bolts, lock washers, washers and nuts.
    ■ Note: the longer of the two bolts is used near the outside of the plate on the passenger (frame) side.
    ○ Tighten down by hand using your 14mm ratcheting wrench.RSG 2010plus
4Runner Cat Skid Guard -

  2. Next, remove the two factory rear skid plate bolts with a 12mm socket.RSG 2010plus 4Runner Cat Skid Guard - skid plate bolts wit

  3. Now it is time to lift up the Cat Skid Guard and loosely fit up the two rear carriage bolts to the transmission crossmember.RSG 2010plus 4Runner Cat Skid Guard - transmission crossmember

  4. Install the included spacers between the factory skid plate and Cat Skid Guard.
    Use the provided hardware and Allen key to tighten down.RSG 2010plus 4Runner
Cat Skid Guard - tighten downRSG 2010plus 4Runner
Cat Skid Guard - tighten down1

  5. Finish it off by tightening down the two rear carriage bolts fully with your 14mm ratcheting wrench, (flex head recommended). Adjust as needed.

RSG 2010plus 4Runner Cat Skid Guard - Adjust as neededRSG 2010plus 4Runner Cat Skid Guard - Adjust as
needed2

ORDERS@RSGOFFROAD.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals