VIVO KB01CB Single Clamp Rotating Keyboard Tray Instruction Manual
- May 15, 2024
- Vivo
Table of Contents
VIVO KB01CB Single Clamp Rotating Keyboard Tray
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please contact our product support team at 309-278-5303 or help @vivo-us.com for further assistance. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
PACKAGE CONTENTS
TOOLS NEEDED
- Phillips Screwdriver
DO NOT EXCEED WEIGHT CAPACITY. Failure to do so may result in serious injury.
ASSEMBLY STEPS
STEP 1
Place Tray Set (A) side by side and note the two sets of pilot holes.
Indentify which set is closer to the combined edge, which will be the back of
the tray. Connect Tray Set (A) to Tray Support (B) from the back using M5x12mm
Screws (S-B) and a Phillips screwdriver.
STEP 2
Remove backing from Non-Slip Pad (G) and apply to underside of Upper Clamp
(C).
STOP HERE
Choose An Assembly Option
The Single Clamp features two screw hole sets to allow an adjustable height of
keyboard tray below desktop. Reference the chart below to determine your
assembly method based on the clearance below the desktop needed for your
setup.
Note : This will impact your leg room and available space for taller
keyboards
STEP 3
Connect Upper Clamp (C) to Lower Clamp (D) using M8x12mm Screws (S-A) and 5mm Allen Wrench (T-A).
Need More Keyboard Clearance? If you are using the upper set of holes and do not have adequate space for your keyboard, switch to the lower set. Place the clamp assembly onto the desktop. Insert 5mm Allen Wrench (T-A) into underside of Lower Clamp (D) and tighten to secure to desktop.
STEP 4
Insert Plastic Bushings (E) into Tray Support (B). Secure Tray Support (B) to
Lower Clamp (D) using Swivel Cap (F).
STEP 5
Place keyboard and mouse on Tray Set (A) and adjust as desired.
NOTE : Requires 33” rotation clearance; ensure there are no under desk obstructions.
Open Monday – Friday 7:00am – 7:00pm CST,
our dedicated support team can offer immediate assistance with rapid response
times. If any parts are received damaged or defective, please contact us. We
are happy to replace parts to ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo- us.com
Documents / Resources
| VIVO
KB01CB Single Clamp Rotating Keyboard
Tray
[pdf] Instruction Manual
KB01CB Single Clamp Rotating Keyboard Tray, KB01CB, Single Clamp Rotating
Keyboard Tray, Clamp Rotating Keyboard Tray, Rotating Keyboard Tray, Keyboard
Tray
---|---
References
- Register a .US.COM domain today!
- VIVO - Desks, Monitor Mounting, and More Home & Office Solutions – VIVO - desk solutions, screen mounting, and more
- Single Clamp Rotating Keyboard Tray – VIVO - desk solutions, screen mounting, and more
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>