Westinghouse PWHOSE50 50 ft PVC Pressure Washer Hose User Manual
- June 17, 2024
- Westinghouse
Table of Contents
Westinghouse PWHOSE50 50 ft PVC Pressure Washer Hose
Product Information
- Specifications:
- Model: PWHOSE50
- Pressure Rating: 3200 PSI
- Length: 50 feet
- Suitable for: Westinghouse Pressure Washers
Product Usage Instructions
- Installing the High-Pressure Hose:
- Thread the collar of the high-pressure hose clockwise onto the trigger handle’s coupler. Be careful not to cross-thread.
- Pull on the hose to be sure it is secure.
- Using the Pressure Washer:
- Hold the trigger handle securely with both hands when the unit is on to reduce the risk of injury from kickback.
- Contact information:
- Service Hotline: 855-944-3571
- Address: 777 Manor Park Drive, Columbus, OH43228 Westinghouse and Westinghouse Electric Corporation are trademarks.
- Review Information:
- 05000420-0 04/27/23 (REV:02)
- FAQ (Frequently Asked Questions)
- Q: How do I ensure the high-pressure hose is securely attached?
- A: Thread the collar onto the trigger handle’s coupler clockwise and pull on the hose to confirm its security.
- Q: What should I do to reduce the risk of injury when using the pressure washer?
- A: Hold the trigger handle with both hands securely to minimize the risk of kickback.
INTRODUCTION
WARNING
- Users must read and understand the operator’s manual for their pressure washer before using this accessory to reduce the risk of injury.
- Fits most pressure washers. Before using this attachment, make sure it is compatible and is correctly installed. Risk of fluid injections.
- Do not point at people, pets, electrical devices, or the unit itself.
- Wear eye protection designated to conform with ANSI Z87.1.
- Before adding, replacing, or modifying accessories, turn off the pressure washer, release the water pressure in the trigger handle, and lock the trigger handle’s lockout (if one is provided with your pressure washer).
- Use only with cold water and only outdoors. Store the accessory indoors.
INSTALLATION
INSTALLING THE HIGH-PRESSURE HOSE See Figure 1.
- A – High pressure hose (manguera de alta presión, tuyau haute pression)
- B – Collar (collar, collier)
- Thread the collar of the high-pressure hose clockwise onto the trigger handle’s coupler.
- Be careful not to cross-thread.
- Pull on the hose to be certain it is secure.
WARNING
- Hold the trigger handle securely with both hands when the unit is on to reduce the risk of injury from kickback.
CONTACT
- Service Hotline: 855-944-3571
- 777 Manor Park Drive, Columbus, OH 43228 and Westinghouse are trademarks of Westinghouse Electric Corporation.
- Used under license by MWE Investments, LLC.
- © 2022 MWE Investments, LLC All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>