delta HL6700R Holder X Smartphone Installation Guide
- June 17, 2024
- Delta
Table of Contents
Smartphone
Holder X
Assembly instructions
HL6700R
-
Mount the clamp securely to handlebars, using shims as needed.
IMPORTANT SAFETY NOTE
Do not attach clamp to any tapered section of your handlebar. -
Rotate in desired position.
Tool Required
Phillips Head Screwdriver
WARNING
Using phone device while riding can cause accidents resulting in serious
injury.
Important: Nuts and bolts can loosen over time, resulting in serious danger
should the item fall off while in motion.
Check frequently to ensure all bolts are properly tightened. Ensure the device
fits snugly in the holder before riding.
Not for off-road use.
Assembly instructions HL6800
Parts
A x1 — Smartphone Holder
B x2 — Spacer Rings (optional)
C x1 — Mount Screw
D x1 — Garmin ® Mount
E x1 — Wahoo ® Mount
Tool Required
Allen Key
Assembly video Visit
designbydelta.com/downloads
- Remove stem cap and insert phone holder,
Using spacer rings as needed.
Reinstall stem cap and tighten stem bolt securely.
IMPORTANT NOTE
Never loosen the stem clamp bolts.
GARMIN ® OR WAHOO ® MOUNTING OPTIONS
-
Use Allen key (2.5mm) to remove mount screw.
(FIGURE 1) -
Choose Garmin ® or Wahoo ® mount, position on to arm. Tighten mount screw with Allen key (2.5mm). (FIGURE 2)
WARNING
Using phone device while riding can cause accidents resulting in serious
injury.
Important: Nuts and bolts can loosen over time, resulting in serious
danger should the item fall off while in motion.
Check frequently to ensure all bolts are properly tightened. Ensure the device
fits snugly in the holder before riding.
Not for of-road use.
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 /
www.designbydelta.com
Service: Please do not return to store; for immediate response email
service@designbydelta.com
Assembly instructions HL6800H
Parts
| A | x1 — Phone Mount |
|---|---|
| B | x1 — Arm with Handlebar Clamp |
| C | x2 — Rubber Shim |
| D | x1 — Handlebar Stem Support |
| E | x1 — Clamp Screw |
| F | x1 — Mount Screw |
| G | x1 — Garmin ® Mount |
| H | x1 — Wahoo ® Mount |
Tools Required
Allen Key (3mm) and (2.5 mm)
(Included)
-
Determine which handlebar shim is best suited for your needs, insert into handlebar stem support (FIGURE 1).
Once attached clip on to handlebar.
IMPORTANT NOTE
Be sure stem support is positioned underneath stem.
-
Slide hinge mount arm over stem support (FIGURE 1). Clamp to close, once in position, tighten clamp screw with Allen key (3mm).
IMPORTANT NOTE
Do not attach clamp to any tapered section of your handlebar.
GARMIN® OR WAHOO® MOUNTING OPTIONS
- Use Allen key (2.5mm) to remove mount screw.
- Choose Garmin® or Wahoo® mount, position on to arm. Tighten mount screw with Allen key (2.5mm).
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 /
www.designbydelta.com
Service: Please do not return to store; for immediate response email
service@designbydelta.comhttps://qrstud.io/rp12gxc
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>