eurowise Porsche Macan Slider Installation Guide
- June 17, 2024
- eurowise
Table of Contents
eurowise Porsche Macan Slider
Product Information
Specifications:
- 6x Small L bolts (cut 2 1 off)
- 2x M12 nutserts large
- 2x M12x30 Hex bolts
- 2x M12 washers
Product Usage Instructions
-
Step 1: Remove Underbody Plastic Covers Start by removing both the left and right underbody plastic covers. These will not be reused.
-
Step 2: Install L Bolts
Insert the L bolts into the pockets of the front and rear. Make sure to install the paper circles over the studs to prevent the L bolts from falling into the frame. -
Step 3: Install Nutserts
Use a nutsert tool (not included) or purchase one from our website to install the M12 nutserts. The large nutsert should be installed on the front side. -
Step 4: Attach Slider and Serrated Nuts
Once the L bolts and nutserts are in place, install the sliders.
Use the M12 bolt on the nutsert and flanged serrated nuts on other spots to secure the slider.
FAQ
- Q: What should I do if I have questions or concerns about the product?
A: If you have any questions, comments, or concerns related to your product, please contact us at 704-559-8100 or email us at [email protected].
Porsche Macan Slider installation
- 6x Small L bolts (cut 2 1″ off)
- 2x M12 nutserts large
- 2x M12x30 Hex bolts
- 2x M12 washers
- Remove both left and right underbody plastic covers. You will not reuse these.
- Installation hardware pack you will see Special L bolts along with paper circles. You will install the paper over the stud to keep the L bolt from falling into the frame.
Insert the L bolt into the pockets of the front and rear.
Front seen with the large nutsert installed. Also, L-bolt installed on the right side.
Nutsert tool not included but can be purchased on our website to make
installation simple. Otherwise, it is a M12 nutsert tool. 
Install serrated nuts on the L bolts with the slider in place. 
Once L-Bolts are inserted and the nutsert is installed. You can install the
sliders. The nutsert will receive the 1 M12 bolt and other spots will get the
Flanged serrated nuts. 
IF YOU HAVE ANY
QUESTIONS, COMMENTS, OR CONCERNS RELATED TO YOUR PRODUCT PLEASE CONTACT US!
440 SPRINGBROOK ROAD. CHARLOTTE, NC 28217 |
704-559-8100
[email protected] |
WWW.EUROWISE.COM |
SHOP.EUROWISE.COM
References
- Specializing in European Service, Performance and Fabrication – Eurowise Performance
- Eurowise Audi, BMW, Volkswagen, Mercedes, & Porsche Service