ULTRALOQ V21 Handle Push Pull Installation Guide
- June 17, 2024
- Ultraloq
Table of Contents
- ULTRALOQ V21 Handle Push Pull Installation Guide
- What,s in the box
- Notes
- Spindle Preparation
- Handle Preparations
- Defult
- Optional
- For outswinging door
- STEP1
- STEP2
- STEP3
- Step 1
- Step2
- STEP4
- Testing the handle
- Warranty Statement
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ULTRALOQ V21 Handle Push Pull Installation Guide
What,s in the box
Notes
- Do not use a power drill for installation.
- Install and test the handle with the door open to avoid being locked out.
- Please read all the instructions before contacting customer support.
- Please contact customer support before returning the product to the store.
- Follow the instructions in sequential order.
Spindle Preparation
There are two spindles to suit doors of different thicknesses. The short spindle is 1%” (40mm), suit for thickness from 15″ (35mm) to 17″ (40mm). The long spindle is 2″ (50mm), suit for thickness from 1%, (45mm) to 2″ (50mm).
Handle Preparations
There are two methods to operate the handle, they are push and pull.
Defult
In the default mode, there is no need to install screw C.
In this case, the door handle on either side can be operated by both pushing
and pulling (with the internal and external
handles remaining parallel).
If you want to ensure that each side of the door handle has a consistent
operating method, please consider the following optional steps.
Optional
For inswinging door
- Insert Screw C into Push hole of the External Assembly.
- Insert Screw C into Pull hole of the Internal Assembly.
For outswinging door
- Insert Screw C into Pull hole of the External Assembly.
- Insert Screw C into Push hole of the Internal Assembly.
Preparing the Door
Please check the door’s dimensions. If your door dimensions do not match, you
will need to change your door
preparation. Go to u-tec.com/collections/accessories to get the ULTRALOQ Thick
Door Kit.
STEP1
- Insert the Latch and Strike. Please align the Latch with the door’s edge.
- .Tighten 2 Screws A on each side to fix the position.
STEP2
Installing the exterior assembly Place the exterior assembly horizontally or
vertically .
Align the spindle with the slot in the latch and slide it into place.
STEP3
Installing the interior assembly
Step 1
Place the interior assembly horizontally or vertically. Align
the spindle with the slot in the interior assembly and slide it into place.
Step2
Tighten Screw B and insert Silicone Nut. Press both sides of the handle together while you tighten the screws to keep the outside and inside handle in place.
STEP4
Testing the handle
Push and/or Pull the handle, the latch should extend and retract smoothly. If it doesn’t operate well, please follow the instructions and repeat the installation.
Warranty Statement
Please check www.u-tec.com for specific warranty details and limitations.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>