DELTA 3575LF Widespread Bathroom Faucet Instruction Manual
- June 17, 2024
- Delta
Table of Contents
INSTRUCTIONS
Manual
WIDESPREAD FAUCET
Installation
Thank you for purchasing our faucet.The faucet you have purchased is crafted
out of the highest quality nickel, brass and stainless steel. Each and every
faucet was tested.
Please read the instructions carefully to prevent any malfunction and damages
to your plumbing and property.
Tools
The tools below are required to complete the installation. Some may not be
needed depending on the model of the faucet that you are installing.
CAUTION : Always shut off the water supply before removing or replacing any part of a faucet. Open the handle to relieve water pressure and ensure that the water is completely shut off.
-
Before Installation
A.Make sure you have all necessary parts by checking the diagram and parts list.
B.Turn off the hot and cold water supply hose at the angle and turn on the old faucet to release any built up pressure. Remove old faucet. Clean sink or counter top preparation for new faucet.
C.Shut off angle stops valve.
D. Pre-drilled hole size requirement:1-3/16″(min)-1-1/2″ (max)
Max counter top thickness without deckplate:1-1/2″ (1 hole install)
Max counter top thickness with deck plate:1″ (1,2 or 3 hole install)
-
Installation Steps
Put the hot(red) water supply hose into the hot(red) handle.
Put the cold(blue) water supply hose into the cold(blue) handle.
(Left is red, right is blue)
Place the handle body through the hole.
Then put on the rubber gasket and metal gasket.
Lock the locking nut and tight with the screw.
(Left is red, right is blue). Place spout in center hole of sink. Assembly
washer and tighten the lock nut to it.
Connect the T-valve to the spout body using the wrench. Assemble the rubber
washer, washer and tighten with lock nut.
Use hoses to connect spout to 2 handle control with fast connector.
Connect hot supply hose (on left side) and cold water supply hose (on right side) to supply outlets.