everwell SK-5 Relay and Hard Start Capacitor Instruction Manual
- June 17, 2024
- everwell
Table of Contents
everwell SK-5 Relay and Hard Start Capacitor
Product Information
Specifications:
- Model Number: SK-5
- Compatibility: PSC single phase, 115V thru 230VAC Air Conditioning Units
- Compressor Torque Increase: 300%
- Capacity Range: 4,000BTU to 120,000BTU (1/2 thru 5HP)
Product Usage Instructions
Installation:
- Ensure the unit is disconnected from the power source.
- Locate the run capacitor on the PSC unit.
- Connect the two wires from the SK-5 in parallel with the run capacitor (one wire each).
- Do not remove any original wires; use the special Piggy Black terminal of the SK-5 if all capacitor terminals are in use.
- Install only on PSC units equipped with a run capacitor.
- Secure all connections properly and ensure they are insulated.
- Reconnect the power source and test the unit.
Frequently Asked Questions (FAQ)
-
Q: Can the SK-5 be used on other types of air conditioning units?
A: No, the SK-5 is designed specifically for use on PSC single-phase air conditioning units within the specified voltage and capacity range. -
Q: What should I do if I encounter difficulties during installation?
A: If you face any challenges during installation, please consult a qualified technician or contact our customer support for assistance.
P/N: SK-5
- Relay and Hard Start Capacitor
- Increases Compressor Torque 300%
- This product can be used on all PSC single phase, 115V through 230VAC.
- Air Conditioning Units from 4,000BTU to 120,000BTU (1/2 thru 5HP)
Installation Instruction
- Connect the two wires from SK-5 in parallel with the run capacitor (one wire each) without removing any original wire. Use the special “Piggy Black” terminal of the SK-5 if all the capacitor terminals are being used.
- INSTALL ONLY ON PSC UNITS EQUIPPED WITH RUN CAPACITOR.
2771Ac.22A No wring changes necessary
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>