UBIQUITI EAH-8 Security Door Controller Cabinet Installation Guide
- June 17, 2024
- UBIQUITI
Table of Contents
Installation Guide
EAH-8 Security Door Controller Cabinet
Installation Guide
Safety Notices (if applicable)
- Read, follow, and keep these instructions.
- Heed all warnings.
- Only use attachments/accessories specified by the manufacturer.
WARNING: Failure to provide proper ventilation may cause fire hazard. Keep
at least 20 mm of clearance next to the ventilation holes for adequate
airflow.
WARNING: To reduce the risk of fire or electric shock, do not expose this
product to rain or moisture.
WARNING: Do notuse this product in location that can be submerged by
water.
WARNING: Avoid using this product during an electrical storm.
There may be a remote risk of electric shock from lightning.
Battery Warning (if applicable)
- Donot expose cells or batteries to heat or fire. Avoid storage in direct sunlight.
- Purchase battery recommended by manufacturer. Risk of explosion if replaced with incorrect type.
Electrical Safety Information (if applicable)
-
Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label.
Connection to a different power source than those specified may result in improper operation, damage to the equipment, or pose a fire hazard if the limitations are not followed. -
There are no operator serviceable parts inside this equipment.
Service should be provided only by a qualified service technician. -
This equipmentis provided with a detachable power cord which has an integral safety ground wire intended for connection toa grounded safety outlet.
a. Do not substitute the power cord with one that is not the provided approved type. Never use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the grounding wire.
b. The equipment requires the use of the ground wire as a part of the safety certification, modification or misuse can providea shock hazard that can result in serious injury or death.
c. Contact a qualified electrician or the manufacturer if there are questions about the installation priorto connectingthe equipment.
d. Protective earthing is provided by Listed AC adapter. Building installation shall provide appropriate short-circuit backup protection.
e. Protective bonding must be installed in accordance with local national wiring rules and regulations.
Declaration of Conformity
Hereby, UBIQUITI, declares that this device, EAH-8, is in compliance with the
essential requirements and other relevant provisions of Directives 2014/30/EU,
2014/35/EU. The full text of the EU declaration of conformity and detailed
compliance information is available at the following internet address:
ui.com/compliance
Ubiquiti International Holding B.V.
Ekkersrijt 3102, Son, Netherlands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>