ACON 35X47IN Air Tracks User Manual
- June 17, 2024
- ACON
Table of Contents
ACON 35X47IN Air Tracks
These instructions apply to the following ACON air track models: air track 3m / 10ft, air beam 3m / 10ft, air block 100x60cm / 40x24in, airport Ø100cm / Ø40in, Carroll 90x120cm / 24x47in, Carroll 60x120cm / 35x47in Thank you for purchasing one of our safe and fun products! With this manual, we want to describe how to use Acon airtracks. Please make sure to read through the instructions carefully before using your track. Should anything be unclear, do not hesitate to contact our customer support! We hope you enjoy your new equipment.
GENERAL INSTRUCTIONS
Choose an appropriate area to set up the track. Ensure that there is nothing sharp underneath the track (such as rocks, gravel, etc.) when setting it up to avoid damaging the track. If you use the track outside, set it on level and soft ground, preferably on top of a protective tarp or fabric. Always store and transport the track in its carrying bag. Do not use the track if it is damaged or leaking air.
- AIRTRACK 3m/10ft
- AIRROLL 90x120cm/24x47in
- AIRBLOCK 100x60cm/40x24in
- AIRSPOT Ø100cm/ Ø40in AIRROLL 60x120cm/35x47in
To clean the track surface, wipe it with lukewarm soapy water. Avoid strong cleaning solutions. Before rolling up the air track for storage, ensure that the air track is clean and dry.
AIRBEAM 3m/10ft
USER MANUAL FOR ACON AIRTRACKS
These instructions apply to the following ACON air track models: air track 3m
/ 10ft, air beam 3m / 10ft, airlock 100x60cm / 40x24in, airport Ø100cm /
Ø40in, Carroll 90x120cm / 24x47in, Carroll 60x120cm / 35x47in
REACH
The recommended temperature for track use is -10 – +30 °C / 14 °F – 86 °F and
for storage, it is at least +5 °C / 41 °F (not recommended to be stored in
direct sunlight). Airtracks can bear 200 kg/m² / 440lb/10.76 ft².
HAND PUMP USER INSTRUCTIONS
Inflating the airtrack: Remove the airtrack from the carrying case and roll it out fully so that the valves are visible. Depending on the model, the air track can have one or two valves; if there are two valves, you can use either to inflate or deflate the airtrack. Only use the pump that is included with the track.
Open valve cover (1). Ensure that the valve button is in the up position (2). Place the head of the pump tube into the valve and twist to the right so that the pump and valve connect tightly (3). The recommended pressure for airtrack is 5-6 PSI. The bounciness of the airtracks depends on how much pressure you put in it. Our recommended pressure level is 5-6 PSI but the most optimal pressure depends on the users’ preferences. Pump until the desired air pressure level is seen on the pump’s air pressure meter. Remove the head of the pump tube by twisting it to the left. Put the valve cover back in place. Ensure that the valve cover is properly in place to avoid air leaking from the airtrack. Deflating the airtrack: Push the valve button into the down position and the valve will open (2).
If air leaks around the valve, follow these steps:
- Remove the valve key from its packing case.
- Open the valve cover and place the valve key in the valve
- Turn the valve key clockwise until there is no space between the valve and the airtrack.
- Do not turn the key counterclockwise as this will cause the valve to loosen, leak air, and eventually detach from the airtrack.
- Close the vent and check to see if the leak stopped.
CONTACT US
EUROPE
Email: customercare.eu@acon24.com
Tel: acon24.com/pages/customer-service acon24.com
USA
Email: customercare.us@acon24.com
Tel: +1-866-297-5234
us.acon24.com
References
- ACON Instruction manuals & guides
- ACON EU – Trampoline Shop online - trampolines and airtracks – Acon EU
- ACON Customer Service | Contact Information | Read more – Acon EU
- Trampolines - Rebounders - Airtracks - ACON USA
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>