Dynojet 2008 Power Commander III User Manual
- June 17, 2024
- Dynojet
Table of Contents
Dynojet 2008 Power Commander III
PARTS LIST
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION DOWNLOAD THE POWER COMMANDER SOFTWARE AND LATEST MAPS FROM OUR WEBSITE: WWW.POWERCOMMANDER.COM
INSTALLATION
The ignition must be turned OFF before installation.
- Remove the plastic electronics cover located above the clutch housing.
- Unplug the ECU connector on the right side closest to the engine as shown in Figure B.
- Attach the PCIII USB connectors to the ECU and the factory wiring harness.
- Route the PCIII USB harness out from under the electronics cover and over to the left side of the air box as shown in Figure C.
- Clean the left side of the air box and the back of the PCIII USB using the supplied alcohol swab and attach the supplied velcro.
- Attach the PCIII USB to the air box.
- Replace the electronics cover.
- Insert the cd provided into your computer’s cd-rom drive.
- Follow the on-screen instructions to install the PCIII USB software. Visit www.powercommander.com to download software tutorials and the latest maps.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>