KENWOOD HMP32 Stand Mixer Instructions
- June 10, 2024
- KENWOOD
Table of Contents
TYPE: HMP32
TYPE: HMP34
instructions
HMP32 Stand Mixer
Safety
- Read these instructions carefully and retain for future reference.
- Remove all packaging and any labels.
- If the plug or cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorized Kenwood repairer in order to avoid a hazard.
- DO NOT process hot ingredients.
- Do not operate your appliance for longer than the times specified below without a rest period. Processing continuously for longer periods can damage your appliance.
**** Function/Attachment| Maximum Operation Time| Rest Period Between Operations
---|---|---
Beaters| 6 mins| Unplug the appliance and allow to cool down for 15 minutes
Kneaders Heavy cake mixes
Bread doughs| 3 mins - Never put the handmixer body in water or let the cord or plug get wet.
- Keep fingers, hair, clothing and utensils away from moving parts.
- Never let the cord touch hot surfaces or hang down where a child could grab it.
- Never use a damaged handmixer. Get it checked or repaired: see `Service and Customer Care’.
- Never use an unauthorized attachment.
- Always switch off the appliance and disconnect from the power supply, if it is left unattended, before assembling, disassembling or cleaning.
- Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
- Misuse of your appliance can result in injury.
- The rated power is based on the chopper attachment. Other attachments may draw less power.
- Children should be supervised to ensure that they do not play with the appliance.
- This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
- Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
Care and Cleaning
- Always switch off, unplug and remove the beaters or kneaders before cleaning.
- Never put the handmixer body in water or let the cord or plug get wet.
- Never use abrasives to clean parts.
Metal Bowl (TYPE HMP34 only)
- Never use a wire brush, steel wool or bleach to clean your stainless steel bowl. Use vinegar to remove limescale. Keep away from heat (cooker tops, ovens, microwaves).
Before plugging in
- Make sure your electricity supply is the same as the one shown on the rear of your Handmixer.
- This appliance conforms to EC Regulation 1935/2004 on materials and articles intended to come into contact with food.
Before using your Handmixer for the first time
- Wash the parts (see `Care and cleaning’).
Key
1. Tool release button
2. Speed selector
3. (P) Pulse button
4. Mixer
5. Beater
6. Beater with gear
7. Kneader| 8. Kneader with gear
9. Mixing bowl
10. Cradle
11. Mixer release button
12. Cradle release button
13. Stand
---|---
To Use your Handmixer
Refer to illustration A
Fitting the beaters/kneaders
Insert the beater/kneader with the plastic gear in the socket.
Setting Up the Bowl & Stand
Refer to illustrations A - E
-
Fit the beaters/kneaders to the Handmixer.
-
Hold the front of the cradle and raise by pressing the cradle release button.
-
Place the bowl onto the stand.
-
Fit the mixer to the cradle and push down to secure.
Note: Check that the beater/ kneader with the plastic gear aligns with the drive gear on the cradle. -
Lower the cradle by holding the Handmixer handle whilst pressing the cradle release button at the same time.
-
Plug in and select a speed (Refer to the recommend usage chart).
After Use
Refer to illustrations F - H
- Switch the speed selector to the `O’ OFF position.
- Hold by the handle and lift up the cradle by pressing the cradle release button.
- Remove the mixer from the cradle by pressing the mixer release button and lifting off.
- Remove the beaters/kneaders hold by the shafts and press the tool release button.
Note: they can only be removed when the mixer is released from the cradle and the speed selector is in the `O’ OFF position.
Hints and Tips
-
As the mixture thickens, increase the speed.
-
If the machine starts to slow or labour, increase the speed.
-
Press the
P’ pulse button to operate the motor at maximum speed. The motor will operate for as long as the pulse is held in position. **Note:** the
P’ pulse button will only operate if a speed is selected first. -
Scrape down the sides and bottom of the bowl at regular intervals to assist the mixing operation’
-
When creaming for cake mixtures, use butter or margarine at room temperature or soften before use.
-
For best results with small quantities, use the handmixer without the stand.
-
Large quantities and thick mixtures may require a longer mixing time.
-
If you wish to mix larger quantities or heavier mixes, remove the mixer from the stand and use a bowl of an appropriate size.
-
To re-knead bread doughs remove the mixer from the stand and use hand held.
Recommended Usage Chart
Please note that these are recommendations for using the stand and supplied mixing bowl. If using the mixer by hand, the speed you select may depend upon the bowl size (if not using the bowl supplied), quantities, the ingredients you are mixing and personal preference. Gradually increase to the recommended speeds below.
Food type| | |
---|---|---|---
Beaters
Egg whites| 3-10| 4 – 5| 1-3
Cream| 200 – 500 ml| 1- 5| 2 – 3
All-in-one cake mixes| 1kg Total weight| 1- 5| 1- 2
Batter| 1 litre| 5| 1
Rubbing fat into flour Adding water to combine pastry ingredients| 250g Flour
weight| 1- 2
2| 4
1
Fruit cake
Creaming fat and sugar Folding in flour, fruit. etc.| 900g Total
weight| 5
1-2| 3 – 4
1
Kneaders
Bread| 450g Flour weight
750g Total weight| 4 – 5| 2 – 3
Optional attachment (not supplied in pack)
Mini chopper – refer to ‘Service and Customer Care” section to order.
Service and Customer Care
- If you experience any problems with the operation of your appliance, before requesting assistance refer to the ‘Troubleshooting Guide’ section in the manual or visit www.kenwoodworld.com.
- Please note that your product is covered by a warranty, which complies with all legal provisions concerning any existing warranty and consumer rights in the country where the product was purchased.
- If your Kenwood product malfunctions or you find any defects, please send it or bring it to an authorized KENWOOD Service Centre. To find up to date details of your nearest authorized KENWOOD Service centre visit www.kenwoodworld.com or the website specific to your Country.
- Designed and engineered by Kenwood in the UK.
- Made in China.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE
WITH THE EUROPEAN DIRECTIVE ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE)
At the end of its working life, the product must not be disposed of as urban
waste. It must be taken to a special local authority differentiated waste
collection centre or to a dealer providing this service.
Recipe
White bread dough
10ml/2 tsp dried yeast (the type that requires reconstituting) 5ml/1 tsp sugar 250ml warm water 450g bread flour 5ml/1 tsp salt 15g lard
-
Place the dried yeast, with the sugar and water, in a mixing bowl and leave to froth. The correct water temperature should be 43°C and can be achieved by mixing one third boiling water with two thirds cold water.
-
Add the remaining ingredients.
Fit the kneaders to the handmixer, then combine the ingredients together on a low speed until the flour is incorporated. Then increase the speed and knead for approximately 2-3 minutes, until the dough is smooth and elastic. Cover with oiled cling film and leave the dough to rise in a warm place for 45-60 minutes. -
Re-knead the dough on maximum speed for 30-45 seconds, keeping the kneaders in the mix.
-
Shape the dough into a loaf, or rolls, and place on greased baking trays. Cover with oiled cling film and leave somewhere warm until it has doubled in size.
-
Bake in a preheated oven at 230°C/450°F/Gas mark 8 for 20-25 minutes (for a loaf) or 10-15 minutes (for rolls). When ready, the dough should sound hollow when tapped on the base.
Troubleshooting Guide
Problem | Cause | Solution |
---|---|---|
Handmixer does not operate. | No power. | Check appliance is plugged in. |
Kneader with plastic gear cannot be inserted into the socket. | Fitting kneader | |
to wrong socket | The kneader with the collar will only fit into the socket. | |
Handmixer starts to slow or labour during processing. | Speed selected too low. | |
Recommended quantity exceeded. | Increase speed. |
Refer to recommended usage chart for speeds and quantities to process.
Do not operate for longer than 3 minutes without a 15 minute rest period with
doughs or heavy cake mixes.
Excessive splashing or flour
spray during processing.| Speed selected too high.
Bowl too shallow or too small for ingredients being processed.| Select a lower
speed initially and increase as the mixture thickens.
Select an appropr. c:r7nimixing bowl.
Unable to remove tools from sockets.| Speed selector not in ’01 position.| To
remove the tools. make sure the speed selector is in the OFF “0” position and
unplug the handmixer.
Press the tool release button.
Pulse button does not operate| Speed not selected first.| The Pulse function
will only operate if a speed has been selected first.
Select a speed and then press the ‘P’ pulse button.
Kenwood Ltd
New Lane
Havant
Hampshire
PO9 2NH
kenwoodworld.com
© Copyright 2022 Kenwood Limited. All rights reserved
141946/3
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>