Westinghouse WST3750 2PC Sound System User Manual
- June 17, 2024
- Westinghouse
Table of Contents
Westinghouse WST3750 2PC Sound System
In the Box
Location of Controls
- LINE IN 1 LED Indicator
- LINE IN 2 LED Indicator
- Bluetooth Indicator
- Infrared Receiver Panel
- [POWER] Button:
- Quick Press – Power ON/OFF
- [MODE] Button:
- Quick Press – Change input mode
- [VOL- |144] Button:
- Quick Press – Skip to previous track
- Long Press – Decrease volume
- [*II] Button: Play/pause media playback
- [VOL+ **] Button:
- Quick Press – Skip to next track
- Long Press – Increase volume
- LINE IN 1 Jack (3.5mm AUX)
- LINE IN 2 Jack (3.5mm AUX)
- DC==14V Power Jack
Setting up the Speaker
Powering the Soundbar and Subwoofer
- Attach the pin of one of the supplied power adapters to the DC -== 14V power jack on the soundbar. Plug the adapter into a working wall outlet.
- Attach the pin of the other supplied power adapter to theDC 14V power jack on the subwoofer.
- Plug the adapter into a working wall outlet. Move the subwoofer’s [POWER] switch to the ON position.
- The subwoofer will automatically connect, wirelessly to the soundbar when both are powered ON.
Mounting the Speaker
- Measure a width of 31.8175 inches on the wall and mark the position of the mounting screws on the wall using a pencil.
- Drill the mounting screws directly into the pencil-marked locations. Allow the screws to protrude approximately 0.3 inches out of the wall so you can easily hook the soundbar onto them.
- Place and slide the soundbar onto the mounting screws. Carefully make sure it is firm and stable.
Replacing the Remote Control Battery
To replace or install the battery, push and slide the battery door out from
the remote control. Replace the battery with a new CR2025 battery with the
positive (+) polarity facing up.
NOTE: When using for the first time, gently pull the protection tab
extending out of the remote control’s battery door.
Pairing the Speaker
- Quick press the [POWER] button. The Bluetooth LED indicator will flash BLUE and RED and a voice will be heard.
- Set your mobile device to search for Bluetooth devices. When your mobile device finds the speaker, select WST3750 from the list of found devices.
- After a successful pairing, a tone will be heard and the Bluetooth LED indicator will flash BLUE. On an iPhone or Android Device
Go to SETTINGS - > BLUETOOTH
The screenshots above are typical of many Bluetooth-enabled devices in the
market today, and are used to assist in the explanation of the paring process:
Your Bluetooth-enabled devices interface and interaction with the Bluetooth
spoker.
may differ slightly from the illustrations above. To maintain the Biuerooth
connection, keep your Bluetooth-enabled device within 30 feet of the speaker
Using the Speaker
NOTE: Please go through the Setting Up the Speaker section of this user guide.
Powering ON/OFF
- Quick press the [POWER] button on the side of the soundbar to turn ON/OFF.
- Quick press the [POWER] button on the subwoofer to the ON/OFF position to turn the speaker ON/OFF.
- Press the [O] button to put the soundbar in standby mode.
Adjusting Volume
Long press the [VOL- 144] (decrease) and [VOL+ |»*] buttons on the side of the
soundbar to adjust volume or use the [«4/P-] and [»#/P+ ] buttons on the
remote control.
Changing Modes
The speaker can switch between Bluetooth and two LINE IN input modes. Once the
soundbar is paired to a Bluetooth device and an AUX-in jack is wired to a
media-playing device, quick press the [MODE] button to switch between these
inputs.
NOTE: For further info on pairing Bluetooth devices to the soundbar see
the Pairing the Speaker section of this user guide. For further info on using
the LINE inputs, see the Using the LINE Inputs section of the user guide.
Playing Music
To enjoy music wirelessly on your soundbar, make sure that the soundbar is
properly paired to your mobile device. If you are pairing the device for the
first time, please consult the Pairing the Speaker section of this user guide.
Playing/Pausing Music
Press the [Il] button on the side of the soundbar or on the remote control to
play/pause media playback.
Using the Speaker (cont’d)
Skipping Tracks
- Quick press the [VOL- k4] button on the speaker or the [«4/P-] button on the remote control to skip to the next track.
- Quick press the [VOL+ |›] button on the speaker or the [»/P-] button on the remote control to skip to the previous track.
Using the Remote Control
The remote control allows full control of music playback and volume adiustment
.
Using the Remote Control
The remote control allows full control of music playback and volume
adjustment.
- [POWER] Button: Enter/leave standby
- [INPUT] Button: Change input mode
- [4/P-] Button: Skip to previous track
- [*I] Button: Play/pause music
- [* /P+] Button: Skip to next track
- [TREBLE-] / [TREBLE+] Buttons:
Adjust treble volume of speaker
- [BASS-1/ [BASS+] Buttons
Adjust bass volume of speaker
- [VOL-1/ [VOL+] Buttons
Adjust overall volume of speaker
NOTE: If the speaker is not responding to the remote’s button presses,
the batteries may need to be changed. See the Replacing the Remote Control
Battery section, earlier in this user manual. Please consult the Replacing the
Remote Control Battery section under the Setting up the Speaker section of
this user guide for further info on setting up the remote control.
NOTE: When using the remote control, for best results point directly at
the infrared receiver panel on the front corner of the soundbar.
Using the LINE Inputs
To use the LINE inputs, insert the 3.5mm end of either of the supplied audio
cables (3.5mm or RCA to 3.5mm) to one of the LINE IN input jacks on the side
of the sound bar. Attach the other end of the audio cable to the 3.5mm jack or
RCA inout iack on vour media olavina device. The soundbar will automatically
switch to the LINE IN and the corresponding LED indicator will turn RED/BLUE.
To switch to and from the LINE inputs, press the [MODE] button on the side of
the soundbar or on the remote control.
Legal Information
READ CAREFULLY AND KEEP THIS MANUAL
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undersired operation. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
WARNING Rain/Moisture
- Do not expose the unit to extreme temperatures (heat or cold), open flames, humid conditions, or wet conditions.
- Do not submerge in water.
- Do not open this product or attempt to repair the unit yourself should it not be working.
Limited Warranty
90 Days Limited Warranty
In the unlikely event that this product is defective, or does not perform
properly, you may within ninety (90) days from your original date of purchase
return it to the authorized service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE
- Call the Customer Support number located below, or go to our website portal to receive an SRO number.
- Provide proof of the date of purchase within the package (dated bill of sale).
- Prepay all shipping costs to the authorized service center, and remember to insure your return.
- Include a return shipping address (no P.O. Boxes), a telephone contact number, and the defective unit within the package.
- Describe the defect or reason you are returning the product.
- Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service center determines this product is defective.
- Products received damaged as a result of shipping will require you to file a claim with the carrier.
The shipping address of the authorized service center is: « Customer Service
Dept. 36 c/o Southern Telecom
400 Kennedy Drive Sayreville NJ 08872
Should you have any questions or problems concerning this product, please
contact our customer service department at:
Customer Support: & Phone:
1-877-768-8481
Monday – Friday 8AM – 10PM (EST)
www.southerntelecom.com
Click on Product Support
Limited Warranty (cont’d)
Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse,
improper installation or operation, lack of reasonable care, and unauthorized
modification. This warranty is voided in the event any unauthorized person
opens, alters or repairs this product. All products being returned to the
authorized service center for repair must be suitably packaged.
Limitation of Warranty
-
THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE) ARE HEREBY DISCLAIMED. NO EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY. -
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. AIT, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING
FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. -
THIS DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTIBILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
Some states do not allow the exclusion nor limitation of incidental or
consequential damages, or limations on how long an implied warranty lasts so
the above limitations on exclusions may not apply to you. This warranty gives
you specific legal rights, and you also may have other rights that vary from
state to state.
WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse
Electric Corporation. Used under license by Southern Telecom, Co. All Rights
Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>