BAlMA K01 Smart Lock User Guide
- June 16, 2024
- BAlMA
Table of Contents
BAlMA K01 Smart Lock
Tuya App
Download and install Tuya App through major App markets. Create a Tuya account and log in. Passwords login, SMS verification code login and social media account login are available in Tuya App.
Add device
Tap add device button on the center of Tuya home page or click the+ icon on the upper right corner of Tuya home page and chose Add Device to enter device adding page. Please press key or use default password 123456 unlocking the device to activate Bluetooth broadcast if the device Bluetooth is not connected. The device will pop up in the search bar when it is ready to connect, click the Add button.
Bluetooth reconnection
Bluetooth will be disconnected between App and device if no data is
transferred in one minute.
Please touch keypad on the device and tap connect on the App device page to
reconnect Bluetooth.
Unlock by App
Click the device to enter the device page, slide the key icon on the bottom of screen to the right to unlock.
Add passwords
Click Member Management on the device page, register passwords for corresponding user. Users can also be added by tap + icon on the upper right Conner. Follow the instructions on App to enter 6-10 digits password and save the password. Up to 20 passwords are allowed to be added. Any numbers can be added before or after the correct password for a total length of 20 digits.
Restore initial settings
Press the writing icon on the upper right corner on device page to enter the
info page. In this page, user can edit the device name, check device
information, update device system or remove the device.
Tap Remove Device and chose Disconnect and wipe data. An indicator light
turning on means the device has been restored to initial settings
successfully. Only default password 123456 can be used to unlock the device
after restoring initial settings.
Low battery alarm
Battery level can be checked on App device page. A red light blinking 3 times after unlocking indicates the battery level is below than 20%. When the battery level reaches 0, the keypad will be disabled, please charge the battery in time.
Charging
Use a Type-C port to charge the battery. A red light turns on while charging,
and the light will become green when the battery is fully charged.
( NOTE : charging power supply cannot be higher than 5V1 A)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable derive: The derive has been evaluated to meet general RF exposure requirement The device can be used in portable exposure condition with out restriction