Zhejiang Balma Lock D05E Cabinet Lock Drawer Lock User Manual
- June 5, 2024
- Zhejiang Balma Lock
Table of Contents
Zhejiang Balma Lock D05E Cabinet Lock Drawer Lock
APP Funtlon: Tuya APP
Battery: Lithium battery
Working temperature: -10’C-45’C
Working humidity: 40%RH-90%RH
USB charging: 5V. Micro USB interface
Before you do the following, m&ke $Ure your phone’$ Bluetooth Is turned on and your phone and padlock are within a reasonable distance, It is recommended to operate within 5 meters.
Connect the APP
Search tor “Tuya” APP in the application market and download it. Open 1heAPP.
- Click the”+” iCor\ in the upper right corner of the a.pp homepge
- Click on the “Security Sensing” ca1e901y on the left
- Find the door tock (BluelOOlh) and Click
- Click s1art 8lue1ooth Ne1work Configuration”, and at the same time inse,t the 81uetooth padlock with USS into the charging state. and turn on the Sluetooth
- On Ihe Bluetooth search Interface. the device name appears. click ”OK” to connect.
- Prompt that the Sluetooth connection is successful
- Sfuetooth unlock, click the unlock bullon on the device interface to unlock.
Fingerprint tock eh&rging iMtruetions
- When charging, the red light is on; when ii is full, the green light is on
- low vollage alarm: after unlock Ing operation, If 1he battery voltage Js lower than 3.6V. The low •101tage alarm time is about 5 seconds, the red ligh1 flashes once every second, and the buzzer sounds.
- Low-voltage proIection: When the voltage is tower than 3.2V, ii will enter the low-voltage protec1ion state, no matter if you touch the tinge,p,int or the bulton. th8(8 will be no response. Now you need to plug in the USB to charge to restore the normal working state.
Product initialization
- Open the APP, enter the unlock interface, and click/ in the upperighl corn8,. Ente( the next inta,tace.
- Click 10 remove the device at the boUom, the interface will pop up at the bottom. cllck on the lnte,lace to unbind and claa, the data, the initialization is successful.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Any
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>