Kruger Matz KM0601 Bluetooth Headset Owner’s Manual

IT’S YOUR LIFE JUST TAKE IT
Traveler K13 Bluetooth headset
KM0601
OWNER’S MANUAL

SAFETY INSTRUCTIONS

Read the instruction manual and safety instruction carefully before first use and keep them for future reference. Failure to comply with the below directions, can cause risk of product damage and/or user injury!

1. Use only authorized accessories.

2. Do not attempt to repair this device yourself. In case of damage, contact with an authorized service point for check-up/repair.

3. Clean this device with soft, slightly damp cloth. Do not use any abrasives or chemical agents to clean this product.

4. Do not dispose of the device or its accessories in fire.

5. Protect this product and its accessories from moisture, humidity, water and any other liquid. Avoid using/storing it in extreme temperatures. Do not expose it to direct sunlight and sources of heat.
   Do not store or use in dusty environment. Avoid using it in the strong magnetic and strong static environment.

6. Do not place magnetic storage media near the device. Radiation from the device may erase the information stored on them.

7. This product is not a toy, do not allow children to play with this device or its accessories.
   Note: the device contains small parts which may pose choking hazard!

8. While using the headset, if the volume is excessively high it may cause hearing damage. Please adjust the volume of the player to a moderate level and balance the time of using.

9. Discontinue using the device if you experience skin irritation or any other discomfort while using.

10. DO NOT wear the headset when sleeping.

11. When driving, you are advised to use the Bluetooth headset to ensure your driving safety. It is dangerous to directly use phone when driving.

PRODUCT DESCRIPTION

1. ON/OFF switch
2. Multifunctional button (MFB)
3. USB-C port (charging)
4. Increase volume/ Next track
5. Decrease volume/ Previous track
6. LED indicator
7. Microphone

BASIC OPERATION

Turn on/ off: To turn on the device, slide the ON/OFF switch up. A voice prompt will be issued, LED indicator flashes blue.
The headset will automatically turn off if pairing is not completed within about 2 minutes.
Slide the ON/OFF switch down to turn off the headset. A voice prompt will be issued, red LED indicator is on for 2 seconds, then goes off.

CALL MANAGEMENT

Answer call: When there is an incoming call, you will hear a voice prompt.
Press the MFB to answer the call.
End call: Press the MFB.
Reject   call: When there is an incoming call, press MFB button twice Last number redialing: Press the MFB twice.
*Call switching:** During call, press and hold the MFB for about 1 second to transfer call to the phone. Press and hold the MFB again to switch it back to the headset.

• The smartphone must support call switching function.
  *Voice dialing:** Press and hold the MFB until you hear a voice prompt.
• The smartphone must support voice dialing function.

MUSIC PLAYBACK MANAGEMENT

Play/ pause: Press the MFB once to pause music. Press the MFB again to play music.
Previous/ Next track: Press and hold the button to go to the previous track. Press and hold the button to go to the next track.
Volume adjustment: Press the button to decrease volume. Press the button to increase volume.

MULTI-POINT FUNCTION

1. Pair the headset with the device A, and then turn off Bluetooth function of the device A.
2. Turn off the headset.
3. Turn on the headset again into pairing mode.
4. Turn on Bluetooth function of the device B and connect with the headset.
5. Turn on Bluetooth function of the device A; the headset will automatically connect with device A (device must support auto connect function); otherwise pair the headset with device A manually.
   Now the Bluetooth headset has connected with the device A and B.

**MULTIPLE CALL MANAGEMENT***

1. When a new call is incoming during current call, press the MFB once to answer the incoming call and end current call.
2. Press the MFB twice until a sound is issued to answer incoming call and put current call on hold.
3. Press the MFB twice again to switch A/B calls.
4. During a tripartite call, press the MFB once to hang up the current call and resume the retained call.

• The function will operate properly if the smartphone supports multiple call management function.

PAIRING

1. Turn on the device by sliding the ON/OFF switch up. The headset automatically enters Bluetooth pairing mode (LED flashes red and blue alternatively).
2. Please keep the headset and an external device close to each other while pairing.
3. Enable the Bluetooth function on your external device and search for the headset (KM0601).
4. Connect with the headset.
5. Successful pairing is signified by a voice prompt.

Notes:

• If pairing is not completed within 2 minutes, the headset will automatically turn off. In that case repeat pairing process according to the instructions given above.
• Every time the headset is switched on, it will connect to last connected device automatically. Please note, your device must be on with Bluetooth function turned on.
• When the devices are paired but the operating distance between them is exceeded, you will hear a voice prompt and the devices will disconnect. If the devices re-enter the operating distance, they will pair automatically.

CHARGING

1. Connect one plug of the included cable into the USB-C port of the headset.
2. Connect the other plug into AC charger or a compatible PC USB port.
3. The red indicator is on when the headset is charging.
4. It takes about 2 hours to fully charge the headset.
5. When the battery is fully charged, the blue indicator is on.

Notes:

• When the battery level is low, LED indicator flashes red every 8 seconds. In that case use the supplied USB-C cable to charge the device.
• The headset will automatically turn off when plugged to a charger.
• Fully charge the headset before first use.
• The producer recommends using only supplied/authorized charging cable.
• The battery is non-removable. Do not attempt to remove the battery from the headset; otherwise the headset may be damaged.
• A fully charged battery can provide up to 8,5 hours of talk time and 130 hours of standby time. The actual talk time and standby time may vary with different settings, way of usage and environment.

CLEANING AND MAINTENANCE

• Clean the device and its accessories using soft and dry cloth.
• Do not use any abrasives or chemical agents to clean this product.
• Store the device turned off and safely protected.
• If the headset is not used for a long time, store it in a dry and well- ventilated place.

SPECIFICATION

Bluetooth profiles: A2DP/AVRCP/HFP/Multipoint (Simultaneous connection with two phones)
Talk time: up to 8,5 h
Standby time: up to 130 h
Charging time: approx. 2 h
Voice guidance and notifications
Voice dialing
Multiple call management
Supports music control
Bluetooth version: 5.2
Bluetooth range: up to 10 m
Bluetooth frequency range: 2,402-2,480 GHz
Maximum output power: -2,85 dBm
Battery status (iOS)
Ports: USB-C (charging)
Compatibility: Devices supporting Bluetooth function
Comfortable and secure attachment on any ear
Battery: 100 mAh
Power supply: 5 V, 500 mA
In set: USB Type-C cable
Lechpol Electronics Leszek Sp.k. hereby declares that Bluetooth headset KM0601 is consistent with directive 2014/53/UE.
Full text of the EU Declaration of Conformity is available at following Internet address: www.lechpol.pl.

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or Its literature, indicates that It should not be disposed with other household wastes at the end of its working life. To prevent possible harm lo the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the  retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract This product should not be mixed with other commercial wastes for disposal.

http://www.krugermatz.com/
is a registered trademark
Made in China for Lechpol Electronics Leszek Sp.k., ul.
Garwolinska 1, 08-400 Miętne.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>