BOULT AUDIO Xcharge Ultra Fast Charging Bluetooth Headset User Manual
- June 4, 2024
- BOULT AUDIO
Table of Contents
XCHARGE
USER MANUAL
Product Introduction
Button illustration:
- Multi-function Button
- USB TYPE-C
- LED indicator
- Volume-/Previous Track
- Volume+/Next Track
- MIC
CHARGING YOUR EARPHONE
Your Bluetooth earphone comes with a built-in rechargeable battery and a
Type-C charging cable
Charge fully before use
Using the charging cable through the corresponding port to charge the battery,
the LED Indicator will show red, while charging, and show blue once fully
charged. Charging time is approximately 1 hrs.
GETTING STARTED
To use your Bluetooth earphones, Please follow the steps below.
1. Ensure your Bluetooth earphones are fully charged.
2. Pair your Bluetooth earphones to a Bluetooth- enabled device prior to use.
(See Pairing Instructions)
Powering On the Earphone
Press and hold the Multi-Function Button for 3 seconds until the blue light on
Powering Off the Earphone Once powered on, press and hold the Multi-Function
Button for 3
seconds until the red lights are on and out.
PAIRING YOUR EARPHONE
1. Power on your Bluetooth earphones and they will enter pairing mode
automatically after 6 seconds if it is not already paired with any devices. If
it already gets connected to a paired device, please disconnect it from that
paired device to enter pairing mode again. 2. Activate the Bluetooth function
of your devices and start to search. 3. Select “BOULT AUDIO CHARGE” from the
listed devices and connect. 4. The indicator will be every 10 seconds once
successfully paired/connected.
Note:
- The earphones should be within 30ft range of your Bluetooth devices while pairing/playing.
- The earphones will automatically power off without connection for 5 minutes
MUSIC MODE
Adjust Volume:
Short press the Volume+ to raise the volume or Volume- to lower the volume by
your Bluetooth devices.
Play/Pause Music:
Once connected, short-press the Multi-Function Button to play or pause music.
Previous Track:
Press and hold the Volume- 1 second to the Previous Track.
Next Track:
Press and hold the volume+ 1 second to the next track.
Voice Assistant:
Once connected, Double click the Multi-Function Button for 2 seconds to
access the voice assistant of your smartphone.
LED INDICATOR
STATUS| INDICATOR
Power On| Blue (slow ash)
Power Off| Red (solid and out)
Charging| Red (solid)
Fully Charged| Blue (solid)
Pairing| Blue/Red (quick ash)
Connected| Blue (slow ash)
Low Power| Red (quick ash)
For a better sound quality experience, suggest using IOS 8.0/ Android 4.3 or above operating system. Product Introduction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>