TELTONIKA TAP100 WiFi Access Point User Guide
- June 16, 2024
- teltonika
Table of Contents
Networks
User Guide
TAP100 WiFi Access Point
TAP100….
QUICK START GUIDE
Scan the QR code for instructions teltonika-networks.com/QSG_TAP100
http://teltonika-networks.com/QSG_TAP100https://teltonika- networks.com/product/rms/
EXTEND YOUR DEVICE CAPABILITIES WITH REMOTE MANAGEMENT OPTIONS!
Scan the QR code to start your free 30eday RMS experience
teltonikasnetworks.com/product/rms/
TECHNICAL INFORMATION
Radio specifications
| RF technologies | WiFi |
|---|---|
| Max RF Power | 20 dBm@WiFi |
Integrated antennas specifications
WiFi antenna| 2x 2400~2500 MHz, peak gain< 4.9 dBi, omnidirectional
Powering
PoE| input: 44-57 VDC, 802.3af
COMPLIANCE INFORMATION
TAP100 access point must be used in compliance with any and all applicable
national and international laws and with any special restrictions regulating
the utilization of the communication module in prescribed applications and
environments.
Simplified EU and UK Declaration of Conformity
Hereby, TEL TON I KA NETWORKS declares that this TAP100 is in compliance with
the essential requirements and other relevant provisions of Directive
2014/53/EU and with Radio Equipment Regulations 2017.
The full text of the EU and UK Declaration of Conformity is available at the
following internet address: wiki.teltonika-
networks.com/view/Certificates Detailed compliance information is available
at the following internet address: wiki.teltonika-
networks.com/view/Certificates
FCC:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
I SED :
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF Exposure Compliance:
This equipment complies with FCC/IC RSS-102 radiation exposure limits set
forth for an uncontrolled environment. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter. This
equipment should be installed and operated with minimum distance 20cm between
the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>