HOSELINK 5642-WG Watering Oscillating Sprinkler User Manual
- June 4, 2024
- HOSELINK
Table of Contents
HOSELINK 5642-WG Watering Oscillating Sprinkler
Kit Contents
- 1x Oscillating Sprinkler
- 1x Hose/ink Accessory Connector
Using the Sprinkler
Step 1
Screw the Hoselink Accessory Connector into the sprinkler.
Step 2
Connect to a water supply by attaching your Hoselink-fitted hose end to the
Accessory Connector on the sprinkler.
Components
Cleaning Tips
By following a few simple cleaning tips, your sprinkler should provide years of reliable service.
- Clean the water inlet filter by unscrewing your Accessory Connector to reveal the filter. Remove, rinse and re-fit.
- Use the provided cleaning pin to clear any clogged spray nozzles. Then, run water throughout with the cleaning pin removed to flush the system
Maintenance Tips
- If sprinkler does not operate properly, remove the cleaning pin from the end and flush water through.
- Drain the sprinkler after use.
- Do not allow water to freeze in the sprinkler.
- Store out of direct sunlight.
- If the sprinkler stops oscillating as expected, spraying some silicone lubricant onto the tabs and underneath the sprinkler should help keep everything moving.
Sprinkler Range
Under good water pressure the Oscillating Sprinkler can cover up to a 12m x 15m rectangle. The range and width can be adjusted by utilising the on/off valves and adjusting the tabs.
Replacement parts available
- Cleaning Pin
- Black Watering Jets
- On/Off Buttons
- Flow Control Dial
Please contact Hose/ink Customer Care team directly to arrange replacement
parts.
For more information visit
hoselink.com.au
or call
1300 900 617
Cultivating Connections
Documents / Resources
|
HOSELINK 5642-WG Watering Oscillating
Sprinkler
[pdf] User Manual
5642-WG, Watering Oscillating Sprinkler, Oscillating Sprinkler, Watering
Sprinkler, Sprinkler
---|---