HOSELINK 5648-WG Impulse Sprinkler Spike User Manual
- June 4, 2024
- HOSELINK
Table of Contents
5648-WG Impulse Sprinkler Spike
**User Manual
User Manual
MODEL: 5648-WG
Impulse Sprinkler Spike
**
Delivering a solid, even coverage over a large distance and sufficiently soaking the full area, this sprinkler can be adjusted to cover a radius of 30° to 360°. Depending on the strength of your water pressure, its coverage can also reach up to 30m in diameter.
KIT CONTENTS
– 1x Metal Ground Spike
– 1x Impulse Sprinkler Head
– 1x Hoselink Accessory Connector
ASSEMBLY
The Impulse Sprinkler comes pre-assembled. By using the foot press that extends out from the body of the sprinkler, simply push the spike into the ground and connect to your Hoselink-fitted hose.
Using the sprinkler head
-
ADJUST THE RADIUS FROM 30° TO 360°.
Turn the two silver rings (reference A on image) at the base of the sprinkler head to set the watering parameter. -
WATER IN A 360° RADIUS.
Lift the silver stopper (reference B on image) to allow free rotation of the sprinkler head in a 360-degree rotation. -
ADJUST THE RANGE AND ARC OF THE WATER.
Lift or depress the silver tab (reference C on image) in front of the water outlet. -
CHANGE THE SPREAD OF WATER.
Screw the pin to the side of the silver tab to interrupt the water flow and spread it closer to the sprinkler.
NOTE: If you do not have a Hoselink hose, you’ll need to convert to
Hoselink’s fittings, or remove the Accessory Connector and use another click-
on male connector.
NOTE: you can use multiple Impulse Sprinklers using a daisy chain of
hoses, however, you will require extremely high-water pressure for this to
work efficiently. Remove the stop cap and use a tap to hose connector set
(item 2310) and a hose end connector (item 2420) to attach another length of
hose that runs to a second sprinkler. We would recommend a maximum of two
sprinklers running off one hose to avoid water pressure issues from occurring.
TROUBLESHOOTING
If the sprinkler head has stopped turning, check for blockages by removing the Hoselink accessory connector and a sprinkler head, then rinse both with warm water. Running warm water through the system with the head removed will remove any debris caught inside. Afterward, spray the tool with silicone lubricant to prevent future blockages.
Replacement Parts
– 1x Replacement Sprinkler Head
– 1x Stop cap
Please contact the Hoselink Customer Care team directly to arrange replacement
parts.
MODEL: 5648-WG
Impulse Sprinkler Spike
For more information visit
hoselink.com.au
or call 1300 900 617
Cultivating Connections
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>