aivituvin AIR 23 Outdoor and Indoor Chicken Coop Instruction Manual
- June 4, 2024
- aivituvin
Table of Contents
aivituvin AIR 23 Outdoor and Indoor Chicken Coop
NOTICE
Please retain these instructions for future reference.
- Firmly secure all bolts,screws and knobs before use.
- Reconfirm that all bolts,screws,and knobs are secure every 90 days.
- Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled.
- Do not use or store this item in the proximity of open flame or flammable/combustible chemicals.
- Be aware that some parts are heavy and have sharp edges.
- Be aware that moving parts can injure,crush and cut.
- If any parts are missing,broken,damaged,or worn,stop using this product until repairs are made and/or factory replacement parts are installed.
- Do not use this item in a way inconsistent with the manufacturer’ s instructions as this could void the product warranty.
TOOLS REQUIRED
HARDWARE
PARTS
PRODUCT ASSEMBLY
- Ensure screw holes on long side of “I1” and “I2” are oriented at top.
- Ensure that all pen- panels have stapled-wire facing inside
- All dowels on “K” with hole on “I1” and “I2” by screw 4xP2.
- Ensure all corner line up before screwing together .
- Align dowels on “A” and “B” with hole on “C” and “D”by screw 6xP2.
- Attach the Coop to the Pen using 6xP2.
- Insert “L” piece into slots inside “C” and “D”.
- Slide “J” into bottom slot of Coop
- Bolt “E’’ and “F” to Coop by 4xP1.
- Screw “H” to “E’’ and “F” by 4xP4.
- Drop in Nest Box floor “G”.
- Screw ladder R into bottom half of lower panel on D by 4xP6, so as not to interfere with sliding door.
- Screw roof panels “O” to the Coop by 8XP4.
- Ensure top roof panels line up with each other before screwing “S” by 4xP5.
- Ensuring the latch with lock on “H” before attach nest box lid at the hinges.
- Connect the Pen to the Coop by 4XP3 on each side.
- Align dowels on “N” with holes on “M1” and “M2” by 4xP2.
- Complete the side pen by screwing the top roof Part Q to the front & back Part M1, M2 ,side Part N by 4xP2.
- Screw the spring latch by 4xP6, please pay attention to the direction
WARNING
Manufacturer and seller expressly disclaim any and all liability for personal
injury,property damage or loss,whether direct,indirect,or incidental,resulting
from the incorrect attachment,improper use,inadequate miantenance, or neglect
of this product.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>