aivituvin AIR 54 62 Inch Rabbit Cage Outdoor Chicken Instruction Manual
- June 9, 2024
- aivituvin
Table of Contents
aivituvin AIR 54 62 Inch Rabbit Cage Outdoor Chicken
NOTICE
Please retain these instructions for future
- Firmly secure all bolts, screws, and knobs before use.
- Reconfirm that all bolts, screws, and knobs are secure every 90 days.
- Fasten screws loosely during initial assembly. Do not fully tighten the screws until the item is completely assembled.
- Do not use or store this item in the proximity of open flame or flammable/combustible chemicals.
- Be aware that some parts are heavy and have sharp edges.
- Be aware that moving parts can injure, crush and cut.
- If any parts are missing, broken, damaged, or worn, stop using this product until repairs are made and/or factory replacement parts are installed.
- Do not use this item in a way inconsistent with the manufacturer’s instructions as this could void the product warranty.
TOOLS REQUIRED
HARDWARE
Overview
PARTS
CARTON 1/3
CARTON 2/3
CARTON 3/3
PRODUCT ASSEMBLY
- Connect the wooden house panel, and screw the left & right panels A1, A2, B, and B1 to the back panel C, D, and E by 12XP3.
- Attach the dividers Part F & G to the left and right side of the wooden house by 10XP3.
- Put layer Part H1 in the lower position of a wooden house, and screw layer Part I in the lower position of the wooden house by 2XP6.
- Put layers Part H1 and I in the middle position of the wooden house.
- Put layers Part H1 and H2 in the upper position of the wooden house.
- Attach the supporting bars in Part K by 4XP1.
- Screw the platform layer Part J to supporting bars by 4XP5.
- Connect the wire panels, screw Part O to Part M, and Part N to Part P by 2XP2 on each side.
- Attach step 08 to the wooden house by 4XP2 on each side.
- Attach 2 supporting bars Part L by 4XP1 on each side.
- Screw shelf panel Part V by 4XP5.
- Connect 2 side wire panels, screw Part Q to Part R and Part Q1 to Part R1 by 2XP2 on each side.
- Attach steps 12 to step 11 by 8XP2.
-
- Connect the front wire panels, screw Part S, T, and U by 2XP2, and screw the supporting bars Part L in the down area by 4XP1.
- Screw the shelf panel Part W in the down area by 4XP5.
- Screw the front wire panels by 12XP3.
- Screw the wire roof Part Y by 8XP4.
- Screw roof Part X to the wooden house by 4XP4.
WARNING
Manufacturer and seller expressly disclaim any and all liability for personal
injury, property damage, or loss, whether direct, indirect, or incidental,
resulting from the incorrect attachment, improper use, inadequate maintenance,
or neglect of this.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>