Polaris Xpedition Reverse Light Kit Instruction Manual

: June 16, 2024
: Polaris

Table of Contents

Installation Manual
Step 1: Remove Seat , Hood, and G r ill
Step 2: Remove Optional Plastics
Step 3: Install Controller, Relay, and F use
Step 4: Remove Side Plastic
Step 5: Mount Light
Step 6: Run Wire To Light
Step 7: Assemble Connectors
Operation of Reverse Lights
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**Polaris Xpedition Reverse Light Kit

**

Installation Manual

Included:

Description	Quantity
Wiring harness	1
Relay	1
Lights	1
Zip Ties	6
Christmas Tree Zip Ties	3
Deutsch Connectors	1

Required Tools:

Trod Bit Set

Metric Wrench Set

Flat Screwdriver (push rivets)

Wire Cutter (trimming zip ties)

Philips Screwdriver

Utility Knife

Read entire manual before beginning the installation process.

Disclaimer: Sam’s Backup Lights is not responsible for any damage due to improper installation.

Step 1: Remove Seat , Hood, and G r ill

Remove two screws from the front of the driver’s seat and tilt seat backward to remove; this will make installation easier.
Loosen grill by turning the locks one-quarter turn.
Lift to remove grill.
Remove hood straps and lift to remove hood.

Step 2: Remove Optional Plastics

If applicable, remove any plastics under dash to access the diagnostic connector and OEM wiring harness.

Step 3: Install Controller, Relay, and F use

Plug supplied diagnostic connector into mini-controller and factory diagnostic connector. Located under the dash on the drivers-side under the steering wheel
Zip tie to OEM wiring harness.
Using the factory holes, zip tie relay, fuse, and related wires using supplied Christmas tree zip ties.
Plug bus bar connector on harness into bus bar.
Feed the Light Blue wire thru the grommet to underside of dash and connect into the mini-controller

Step 4: Remove Side Plastic

Remove the screws and push rivets holding the side plastics on

Step 5: Mount Light

Attach the light to its bracket. Be sure to slide the bolt through the bracket before bracket is attached to light.
Depending on model and options mounting location will change.

Step 6: Run Wire To Light

Run harness from battery to the LED Light.
Follow the factory wiring harness and secure the light wiring keeping away from heat and moving parts.

Step 7: Assemble Connectors

Assemble the connector by pushing the red wire into the hole marked 1 and the black into hole 2. Push the wires in until they click into place and lock into the connector. Then push the cap onto the top.
Plug the connector into the light and secure the wire using zip ties.

Operation of Reverse Lights

Our controllers have been programmed with a manual override feature. Back-up lights may be turned on without the vehicle in reverse.

Fully Automatic when shifted to Reverse Gear

No programming required

Manual Override Function

Shift the vehicle into Neutral
Press and hold the brake pedal for up to 2 seconds. The reverse light will automatically turn on and stay on.

*To turn the light off repeat this procedure.

Note: If the ignition is turned off while the vehicle is in reverse, or the manual override function is enabled the lights will remain ON until the ECU enters sleep mode (approximately 30 secs to 2 minutes depending on vehicle and ECU type).