CL LIGHTING LDWSC6171 LED Floor Light User Manual
- June 16, 2024
- CL LIGHTING
Table of Contents
CL LIGHTING LDWSC6171 LED Floor Light User Manual
Features
Product Parameters
Voice control
Turn on the third-party intelligent speaker you want to connect like Alexa, Google Assistant etc. Make sure they connect to same WiFi, and go to the APP to search for the devices and get authorized, then you can voice control the lights with the standard command words.
Installation
- Take the base, pass the power input cable of the light body through the base, twist the tail plug into the nut of the base.
- Take one segment of the light and install the intermediate plug, then align it with the guide slot then plug int.(install all three segments of the light body with same way)
- Clamp the first plug tightly to the top. 4. Plug the light body’s connection cable into the controller tightly, plug in the 5V power supply and start using.
Operation
Short press: Turn on the light, or modes adjustment
Long press: Turn off the light
APP Operation
- Download and install the APP of Smart Life, open your mobile phone’s WiFi and BLE, long press the switch button for over 3 seconds to make the light into quick flash internet pairing mode. Search or add the device on the APP, and log in with the WiFi password to start internet pairing.
- After pairing success, you can start to operate the APP to control the light to change colors, adjust brightness, change the modes, set timer and share your accounts etc.
Remote controller operation
Power supply: 3V button cell
Control distance: 5-8 meters in open area
Remove the PVC film on the back of the remote controller before use, and press
the power button before operation.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a
class B digital device,pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>