GE 14010 6-Outlet Surge Protector Instruction Manual

: June 15, 2024
: GE

Table of Contents

GE 14010 6-Outlet Surge Protector
Product Instructions
Surge Protector — Limited-Lifetime Warranty
Connected equipment claim procedure
FREQUENTLY ASKED QUESTIONS
VIDEO – PRODUCT OVERVIEW
Read User Manual Online (PDF format)
Download This Manual (PDF format)

GE 14010 6-Outlet Surge Protector

GE 14010 6-Outlet Surge Protector Instruction Manual

Product Instructions

Move the power switch into the “OFF” position. Plug the surge protector into a standard grounding wall receptacle by fully inserting the plug and ensuring that there are no exposed conductors.
Make sure electronic equipment is turned off before plugging into the surge protector outlets. Do not use extension cords to connect equipment to the surge protector.
Move the power switch into the “ON” position. The surge protector will now be providing power and surge protection.
Connected equipment can now be turned on.

NOTE: Check the red “Protected” indicator light periodically. A glowing red indicator light shows that surge protection is being provided. If the red “PROTECTED” indicator light stops glowing, the surge protective components have expired* and the surge protector should be replaced.

NOTE: This device features internal protection that will disconnect the surge protective component at the end of its useful life but will maintain power to the outlets – now unprotected. If the indicator light goes out, this unit will no longer provide surge protection as intended and should be replaced.

Surge Protector — Limited-Lifetime Warranty

Jasco Products Company warrants this surge protector to be free of defects in workmanship and/or materials for the life* of the surge protector. If such a defect should arise during the life of the surge protector, Jasco Products Company will, at its option, either repair or replace the surge protector without charge. This warranty does not cover damage caused by lightning, accident, misuse, or alterations to the surge protector.
This surge protector, like all surge protectors, has a finite lifespan. Even under normal circumstances and in the absence of defects, the product’s life will expire when the surge protector’s component capacity has been exceeded, thereby ceasing to provide protection from surges. In this event, the Limited Lifetime Warranty is no longer valid and the surge protector should be replaced.

Warranty replacement procedure

Call the Jasco Products Company Customer Information Center at 1-800-654-8483 to get a Return Authorization Number (RA#), shipping instructions, and a prepaid return address label.
After you have received the prepaid return address label, return the Jasco Products Company surge protector, freight prepaid, to Jasco Products Company. Surge protectors returned to Jasco Products Company must have an RA# included in the mailing address to be accepted.
The original purchaser will be asked to send the surge protector, a copy of the sales receipt for the product, your name, address, phone number, and a description of the problem.

Connected Equipment Warranty

Equipment Replacement Guarantee for Surge Model: 14010 Maximum Warranty Amount: $80,000(USD)

NOTE: This device is not a lightning arrestor, so it will not afford protection when lightning strikes a nearby power line, the house, the service entrance, or the antenna. The Warranty is void if a power disturbance damages your equipment through the phone, coax or network lines. You are only covered if the disturbance enters through the AC lines.

Jasco Products Company will pay up to the maximum warranty amount offered for the surge protector purchased to repair or replace up to an amount equal to the fair market value or the original purchase price, whichever is less, of your electronics equipment, if damaged by a transient surge (except those caused by direct lightning), within the life* of the surge protector, while properly and directly connected to this surge protector. Jasco Products Company DISCLAIMS AND ASSUMES NO LIABILITY FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE OR DATA OR DAMAGES OR COSTS ASSOCIATED WITH BUSINESS INTERRUPTION OR OTHER DAMAGES DUE TO LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE OR DATA. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that may vary from state to state.
This warranty is secondary to any existing coverage of any connected equipment, including but not limited to, any manufacturer’s warranty, extended warranties, or insurance coverage.

To qualify for a connected equipment warranty:

All connected equipment must be UL and/or CSA-approved.
The Jasco Products Company surge protector must be plugged into properly wired and grounded outlets, no extension cords, adapters, other ground wires, or electrical connectors ma be used, with the sole exception of other standard Jasco Products Company 120-volt products approved for that use. The installation must comply with all applicable electrical and safety codes set forth pursuant to the National Electrical Code (NEC.)
Any claim under the warranty policy must be made within 15 days of the date of the alleged damage to the connected equipment.

For connected equipment coverage, the following conditions must be satisfied:

All equipment eligible for warranty coverage must be plugged directly into the Jasco Products Company surge protector. Equipment connected to the protected equipment, but not plugged directly into the surge protector will not be covered.
The equipment must have been damaged by a covered power disturbance that passed through the Jasco Products Company surge protector.
The Jasco Products Company surge protector must be found defective.
The Jasco Products Company surge protector’s protection capacity must not have been exceeded.

Connected equipment claim procedure

Call the Jasco Products Company Customer Information Center at 1-800-654-8483 to get a Return Authorization Number (RA#), shipping instructions and a prepaid return address label.
After you have received the prepaid return address label, return the Jasco Products Company surge protector, freight prepaid, to Jasco Products Company. Surge protectors returned to Jasco Products Company, Inc. must have an RA# included in the mailing address to be accepted.
Jasco Products Company will determine whether the damage to your equipment is covered by this warranty policy. If you are covered, a claims adjuster will contact you and Jasco Products Company will do one of the following at its own discretion:
- Authorize a service center to repair damaged equipment.
- Replace damaged equipment with equivalent or better.
- Reimburse customers the fair market value of the damaged equipment.
- Reimburse the customer the initial purchase price of the damaged equipment (customer to provide dated bill of sale).
Jasco Products Company retains the right to determine whether the damage to the connected equipment is due to Jasco Products Company surge protector failure by requesting that damaged equipment be sent to Jasco Products Company for inspection.

WARNING

RISK OF ELECTRIC SHOCK

DO NOT USE IN WET LOCATIONS
KEEP CHILDREN AWAY
USE INDOORS ONLY
FULLY INSERT PLUG

RISK OF FIRE

DO NOT EXCEED ELECTRICAL RATINGS

NOT FOR USE WITH

AQUARIUMS OR OTHER WATER-RELATED PRODUCTS
GENERATORS AND POWER INVERTERS
MEDICAL LIFE-SUPPORT PRODUCTS

MADE IN CHINA

GE is a trademark of General Electric Company and is under license by Jasco Products Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114. This Jasco product comes with a limited lifetime warranty. Visit www.byjasco.com for warranty details and product registration.

Questions? Contact us at 1-800-654-8483 between 7:30 AM—5:00 PM CST.