R G GSX-8S Second Skin Polyurethane Protective Film Instruction Manual

June 15, 2024
R G

R &G second skin fitting instructions for suzuki gsx-8s 2023-

GSX-8S Second Skin Polyurethane Protective Film

R G GSX 8S Second Skin Polyurethane Protective Film

This R&G Second Skin Stone Chip Protection kit is for the Suzuki GSX-8S 2023-
Please read the fitting instructions below, to ensure maximum satisfaction from your purchase. To ensure a perfectly clear appearance, the surface where the film will be applied needs to be perfectly clean and free from tar, grease and other contaminants.
flamp
Setap 1 Clean the surface to be applied to thoroughly, using the enclosed isopropyl wipe or degreaser, do not use products such as methylated spirits, lighter fuel or white spirits as these leave behind a greasy residue that will affect the ability of the adhesive to bond to the surface to be protected.
Setap 2 Use the enclosed diagram to identify the parts to be fitted.
Setap 3 Fill the spray bottle with water, the spray bottle contains a small amount of concentrated lubricant that when mixed with water will produce a fitting solution. Once the surface has been cleaned and all contaminate removed, spray the fitting solution onto the area of paintwork to be protected. At the same time, generously spray the adhesive face of the part to be fitted with the filling solution. This will significantly ease positioning of the protection film and float into position. Avoid touching the adhesive when dry, as this will leave a fingerprint in the film. If you don’t wear gloves, wet your fingers to avoid fingerprints.
Setap 4 Once the film is correctly positioned, start applying the film, working with half of the film at a time, using a squeegee to expel 100% of air and liquid from the centre towards the edges. Also spray the top face of film to allow the squeegee to slide smoothly and avoid scratching the film. For curved surfaces, pull gently in the direction required and you will find that the film will naturally take to the curvature of the panel. Continue to push out all the remaining water or air bubbles from under the film ensuring the squeegee sildes smoothly from the middle area of the film to the outside edges. This will produce a perfectly dear look. If the film needs to be repositioned during the application process, remove it partially and respray some liquid on both the surface being protected and the adhesive side of the film.R G GSX 8S Second Skin Polyurethane Protective Film -
Fig If any creases appear in the film work out towards an edge using either the squeegee or your thumb to gently spread the film. CD Dry off any excess fluid with a paper towel and finally, use a hair dryer or heat gun to warm up the film to ensure a strong and long lasting bond. Do not exceed 80°C. Appicaocn Imperatore. RSG Second Sbn should not be wiled at a temperature Wow 13’C The wrface to to proxced shotIO be cordooned to a lerrpereure of be:ween 13’C and 25’C Application in Brea sunisit orwindy cot dbons shald be avoided. Cn a keg parrad surface. R&G Second Slayshall rot be WOW WO tie OM IS CMOS* curet AFt/Yeg a raysolvs no a pant that is nct luny axed may resit in a poet ‘able aspect (bubbling the to pant ocrgasseg). Please wait lax pant menhauret s naucbons regarcing rie currg process

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals