SUNCO Selectable Gimbal Slim LED Lights Installation Guide
- June 7, 2024
- SUNCO
Table of Contents
The Brighter Choice
SELECTABLE GIMBAL
SLIM LED LIGHTS
Install Guide and Manual
COMPONENTS
EASY INSTALLATION
-
Turn off a circuit breaker that provides power to the light switch for the recessed lights.
-
Cut a hole in the ceiling in the desired location according to the dimension indicated.
• 3” Housing: 3.35”
• 4” Housing: 4.33”
• 6” Housing: 6.38”
-
Run an electrical wire from the power source (switch) through the mounting hole.
-
Open the junction box and remove the appropriate knockout on the side plate.
-
Connect the supply wires to the junction box wires using the wire nuts provided.
• White to white
• Black to black -
Tuck the connected wires inside the junction box and close the cover.
-
Connect the junction box to the gimbal. Tighten the connector by hand.
-
Turn on the power and test light.
-
BEFORE PROCEEDING:
On the back of the j-box, slide the CCT Selection Switch to choose from five color temperatures (2700K, 3000K, 3500K, 4000K, 5000K). Try each CCT to determine which suits your room.
• Light will use the preferred setting whenever you turn on the switch.
• Turn off the light switch and continue to install.
-
Insert junction box through the hole in the ceiling.
• New construction applications: Hardwire box shall be secured to studs, joists, or similar fixed structural units.
• Remodel applications: Does not require the hardwire box to be firmly secured after the mounting plates
studs, joists, or structural units have been concealed.
-
Adjust flexible optic position to aim the light beam where needed. Gimbal rotates 360° and tilts 35°.
-
Push up the spring clips to insert the luminaire in the opening in the ceiling.
-
Turn on the circuit breaker and test the light.
SPECIFICATIONS
| Product Size | 3 ‘ | 4′ | 6″ |
|---|---|---|---|
| Voltage | 120V | ||
| Wattage | 7W | 12W | 14W |
| Lumens | 500 | 750 | 900 |
| Weight | 0.37 lbs | 0.44 lbs | 0.64 lbs |
| Suitable for Locations Ingress | Damp | ||
| Warranty | 7 years |
WARNING
To reduce the risk of fire, electric shock or injury to people:
-
This product should be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product and the hazards involved. -
Abide by related regional and local laws or regulations.
-
Do not alter, relocate or remove wiring.
-
Do not make or alter any open holes in an enclosure or electrical components.
-
Proper grounding is required to ensure safety.
-
Check for damage during shipping prior to installation. If the product is damaged,do not use it.
-
Turn off the switch and circuit breaker before installing this LED light.
-
Use safety precautions. Safety eyeglasses and gloves are recommended.
-
Please review instructions carefully before proceeding.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>