EKVIP 022178 String Light Instruction Manual
- June 9, 2024
- EKVIP
Table of Contents
EKVIP 022178 String Light
STRING LIGHT
OPERATING INSTRUCTIONS
Original instructions
Jula AB reserves the right to make changes to the product. Jula AB claims copyright on this documentation. It is not allowed to modify or alter this documentation in any way and the manual shall be printed and used as it is in relation to the product. For the latest version of operating instructions, refer to the Jula website.
SAFETY INSTRUCTIONS
- Do not connect the product to a power point while the product is still in the pack.
- Only intended to be used indoors.
- Check that no light sources are damaged. Defective light sources cannot be replaced.
- Do not connect two or more string lights together electrically.
- No parts of the product can be replaced, or repaired. The whole product must be discarded if any part is damaged.
- Do not use sharp or pointed objects during assembly.
- Do not subject the power cord or wires to mechanical stress. Do not hang objects on the string light.
- This is not a toy. Be careful if using the product near children.
- Disconnect the transformer from the power point when the product is not in use.
- This product must only be used together with the supplied transformer and must never be connected directly to the mains supply without a transformer.
- The product is not intended to be used as general lighting.
- Recycle products that have reached the end of their useful life according to local regulations.
WARNING!
The string of lights may only be used if all seals are fitted correctly.
SYMBOLS
SYMBOLS
| Read the instructions.
| Approved as per applicable directives.
| For indoor use only.
| Class II.
---|---
| Recycle discarded product in accordance with local regulations.
TECHNICAL DATA
- Rated input voltage 230 V ~ 50 Hz
- Rated output voltage 3.5V AC
- Output 2.1 W
- No. of LEDs 20 pcs.
- Protection rating IP20
USE
LIGHT MODE
There are ten different light modes. Press the switch to select the required
mode.
| Number of times to press | Light mode |
|---|---|
| 1 | Combination |
| 2 | Warm white constant |
| 3 | Multicolour constant |
| 4 | LED 1 warm white flashing |
| 5 | LED 2 multicolour flashing |
| 6 | Led 1+2 sequential |
| 7 | LED 1+2 flashing |
| 8 | LED 1+2 slow toning |
| 9 | LED 1+2 slow glowing |
| 10 | Off |
TIMER
The timer is activated by pressing the switch for 3 seconds. The timer
switches on the string for 6 hours after which it goes off for 18 hours,
switches on for 6 hours and then switches off for 18 hours. Press the switch
to switch off the timer function.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>