GM Lighting 24VDC Surface Recess Mount LED Slim Puck Instruction Manual

June 4, 2024
GM Lighting

GM Lighting 24VDC Surface Recess Mount LED Slim Puck

BEFORE YOU START

  • Please check local electrical codes before beginning
  • Turn power off before installing
  • Make sure to use proper rated wire

TOOLS NEEDED

  • Keyhole Saw
  • Phillips Screwdriver

RECESSED INSTALLATION

  1. Determine the position of your puck(s) and trace a 2-1/4” diameter circle on surface material. Using a keyhole saw or2-1/4” (58mm) drill bit – cut through surface

  2. Feed Puck wire through hole, and screw puck mountingring into surface using two screws
    (supplied)

  3. Connect feed wires to power supply and snap SlimPuckTrim to SlimPuck. Trim is held magnetically. No need forscrews GM Lighting-24VDC-Surface-Recess-Mount-LED-Slim-Puck-FIG-2

SURFACE INSTALLATION

  1. Determine the position of your puck(s) and positionSlimPuck surface mount ring. Screw surface mount ringonto surface
  2. Making sure that you insert feed wire through SlimPucksurface mount ring slot, position SlimPuck onto surfacemount ring. Ring is held magnetically. No need for screws
  3. Connect feed wires to power supply and snap SlimPuckTrim to SlimPuck

NOTE: Pucks can be mounted in series. Please observe wattage limitations of power supply.

Example : A 20 watt power supply can power up to 8 2-watt Slim Pucks.

USE ONLY ELECTRONIC POWER SUPPLIES. DO NOT LOAD POWER SUPPLY ABOVE 80% OF MAXIMUM

GM Lighting-24VDC-Surface-Recess-Mount-LED-Slim-Puck-
FIG-4

NOTE : USE ELECTRONIC POWER SUPPLIES ONLY.MAGNETIC POWER SUPPLIES ARE NOTOPERABLE WITH THIS FIXTURE

©2022 GM LightingSpecifications are subject to change 18700 Ridgeland Ave. 150 Tinley Park, IL 60477

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

GM Lighting User Manuals

Related Manuals