LECO Oval-Schirm Parasol Oval Umbrella Instruction Manual

Table of Contents

LECO-Oval-Schirm-Parasol-Oval-Umbrella-product

Before Use
- Read these instructions carefully before use and assembly and keep them for future reference!
- Make sure the product meets your expectations and the packaging is undamaged.
Assembly
- Find a suitable stand for the parasol and place it on firm ground.
- Use the details provided on the last page to select an appropriate parasol stand.
- Do not use the parasol without a parasol stand.
- The assembly should be done with two persons.
Usage
- The parasol is intended for daily opening and closing under moderate weather conditions.
- Note: This product is not suitable for commercial use.
Specifications
- Product Name: Oval – Schirm / Oval – Parasol / Ovaal – Parasol
- Assembly Dimensions: Approximately 470 x 270 x H 245 cm
- Article Numbers: Art. 47 20300 103, Art. 47 20300 114, Art. 47 20300 214
- Dimensions: Approximately 460 x 270 x 245 cm
FAQ
- Does this product meet your expectations?
- Before assembly of the product, please check if the kit is complete and accurate based on the spare part list.
- Is the packaging undamaged?
- Make sure the packaging is undamaged before assembly.
- Can I use the parasol without a stand?
- No, it is not recommended to use the parasol without a suitable stand.
- Can I use this product for commercial purposes?
- No, this product is not suitable for commercial use.

Read these instructions carefully before use and assembly and keep them for future reference!

Read these instructions carefully before use and assembly and keep them for future reference!
Place the parasol on firm ground with a suitable stand.
Please select an appropriate parasol stand according to the details on the last page. Do not use it in case no stand on hand.
The parasol is intended for daily opening and closing under moderate weather conditions.

Note: Not suitable for commercial use.

Important Notes!

Does this product meet your expectations? Is the packaging undamaged?
Before assembly of the product please check if the kit is complete and accurate on the basis of the spare part list.
Defects or missing parts have to be notified before assembling the product.
The manufacturer cannot be held responsible for damages caused during the assembly of the product, for example, scratches or dents.

$LECO-Oval-Schirm-Parasol-Oval-Umbrella-fig-1 $1$$

Information

$LECO-Oval-Schirm-Parasol-Oval-Umbrella-fig-1 $2$.$

Please close the parasol during strong wind and hard rain! Please do not use in near grills, barbecues, fire, etc! $LECO-Oval-Schirm-Parasol-Oval-Umbrella-fig-1 $4$$

Ensure that no persons or objects are in the vicinity of the opening area before opening the sunshade.
Do not grasp during opening or closing between the parts of the frame or the grab pole of the sun shade.
- Risk of injury by crushing! Clean with a damp cloth, and keep protected when not in use.
This product is only for the private sector. Any commercial use is prohibited! No use as sports or fitness equipment! $LECO-Oval-Schirm-Parasol-Oval-Umbrella-fig-1 $8$$
Important Notes! All screws, fasteners, fittings, etc. must be checked regularly.

All sunshade and floor stand components should be stored in a dry and frost-free location during long periods of non-use and over the winter months.

Storage

All sunshade and floor stand components should be stored in a dry and frost-free location during long periods of non-use and over the winter months.

Cleansing

Please use a soft brush and a bit of soapy water to clean the cover fabric. You can find information about cleaning the canopy material on the label sewn onto the canopy.
Clean up the frame components with a mild detergent. Please use only soft, moist cloth or sponge, no scratching or strong tools, to avoid damage on the surface.

Read all instructions before assembly and using this product!

Select an ideal location for assembling. Set out all parts on a clear and level surface before assembly. Ideally, the product should be set up in the desired location to avoid moving it after assembly.
Use caution. During the process of assembling, especially when lifting heavy or large parts, pay attention to safety. No one other than those assistants should be allowed in the work area.
Check all parts available. Before assembling your product, make sure that you have all the parts described in the Parts List.
Keep children away. Children shouldn’t be allowed in the work area. Do not let them handle parts and tools. Do not allow children to climb on when it is in use.
It is also recommended to store and secure the products during inclement or stormy weather or remove them completely.
If after some time small rust spots occur on your product, that mostly only will be surface rust on parts of steel tubes. This rust can be quickly and easily removed and covered by using some usual paint.
Carefully remove all packaging material and dispose of it according to type. Should you wish to dispose of the product after a long period of use, please observe the local regulations regarding the disposal of the different materials of the product.

Manufactured for