LECO 637083 Hanging Parasol with Cross Base Instruction Manual
- June 2, 2024
- LECO
Table of Contents
LECO 637083 Hanging Parasol with Cross Base
Hanging Parasol with cross base
Read these instructions carefully before use and assembly and keep for future reference!
-
Read these instructions carefully before use and assembly and keep for future reference!
-
Place the parasol on firm ground with a suitablestand.
-
Please only use the included parasol stand.
Do not use in case no stand on hand. -
The parasol is intended for daily opening and closing under moderate weather conditions.
Note: Not suitable for commercial use.
Assembly dimensions
ca. 300 x 300 x H 252 cm
**Assembly with 2 persons!
**
Important Notes!
Does this product meet your expectations? Is the packaging undamaged?
Before assembly of the product please check if the kit is complete and
accurate on basis of the spare part list. Defects or missing parts have to be
notified before assembling the product. The manufacturer cannot be held
responsible for damages caused during assembly of the product, for example
scratches or dents.
Spare part list
Information
CAUTION SCISSOR ACTION ! RISK OF INJURY BY CRUSHING! NEVER LEAVE CHILDREN UNATTENDED ! KEEP OUT OF REACH OF CHILDREN !
Assembly instruction
All screws just tighten loose!
Please add 4 pcs. concrete slabs, stone slabs, fillable plastic sheets, etc.
with the dimensions of approx. 40 x 40 x 4 / 5 cm, 45 x 45 x 4 / 5 cm / 50 x
50 x 5 cm, etc. Minimum stand weight of cross base with weighting approx. 50
kg! Without weighting any use is prohibited!
Fasten the parasol in the umbrella base!
Now please tighten screws firmly!
Please control screws regularly!
Operation
Ensure that no persons or objects are in the vicinity of the opening area
before opening the sunshade. Do not grasp during opening or closing between
the parts of the frame or the grab pole of the sun shade. Risk of injury by
crushing!
Locking lever!
Turn the crank clockwise the parasol opens!
Turn the crank counterclockwise, the parasol closes!
Rotate parasol carefully!
Parasol can be rotated 360 degrees!
Locking lever!
Operation
Clean with a damp cloth, keep protected when not in use. This product is only
for the private sector. Any commercial use is prohibited! No use as sports or
fitness equipment!
Open and close carefully!
Do not hang anything on the parasol!
Please close the parasol during strong wind and hard rain!
Please do not use in the near of grills, barbecue, fire, etc!
Storage
All sunshade and floor stand components must be stored in a dry and frost-free location during long periods of non-use and over the winter months.
Cleansing
Please use a soft brush and a bit of soapy water to clean the cover fabric. You can find information about cleaning the canopy material on the label sewed onto the canopy. Cleanup the frame components with a mild detergent. Please use only soft, moist cloth or sponge, no scratching or strong tools, to avoid damages on the surface.
Important Notes!
All screws, fasteners, fittings, etc. must be checked regularly.
100 % Polyester (PES)
WATER REPELLENT
Please close the parasol during strong wind and hard rain!
Please do not use in the near of grills, barbecue, fire, etc!
-
hand wash
-
Do not bleach!
-
Do not tumble dry!
-
Do not iron!
-
Do not dry clean!
Read assembly manual carefully!
INFORMATION
Read all instructions before assembly and using this product!
-
Select ideal location for assembling. Set out all parts on a clear and level surface prior to assembly. Ideally, the product should be set up in the desired location to avoid moving it after assembly.
-
Use caution. During all the process of assembling, especially when lifting heavy or large parts, pay attention to safety. No one other than those assistants should be allowed in the work area.
-
Check all parts available. Before assembling your product, make sure that you have all parts described in the Parts List.
-
Keep children away. Children shouldn’t be allowed in the work area. Do not let them handle parts and tools. Do not allow children to climb on when it is in use.
-
It is also recommended to store and secure the products during inclement or stormy weather or remove them completely.
If after some time using small rust spots occur on your product, that mostly only will be surface rust on parts of steel tubes. This rust can be quickly and easily removed and covered by using some usual paint. -
Carefully remove all packaging material and dispose of it according to type. Should you wish to dispose the product after a long period of use, please observe the local regulations regarding the disposal of the different
materials of the product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>