LECO Balcony Parasol Instruction Manual
- October 30, 2023
- LECO
Table of Contents
Balkon-Sonnenschirm
Grösse / Size / Maat:
ca. 160 x 200 x 203 / 240 cm 
Read these instructions carefully before use and assembly and keep for future reference!
Assembly dimensions
Art. 47 20410 103 Balkon-Sonnenschirm
Art. 47 20410 105 Balkon-Sonnenschirm
Art. 47 20410 108 Balkon-Sonnenschirm
Art. 47 20410 109 Balkon-Sonnenschirm
Art. 47 20410 214 Balkon-Sonnenschirm
Assembly with 2
persons!
- Place the parasol on firm ground with a suitablestand.
- Please select an appropriate parasol stand according to the details in last page. Do not use in case no stand on hand.
- The parasol is intended for daily opening and closing under moderate weather conditions.
Note: Not suitable for commercial use.
Important Notes!
Does this product meet your expectations? Is the packaging undamaged?
Before assembly of the product please check if the kit is complete and
accurate on basis of the spare part list. Defects or missing parts have to be
notified before assembling the product. The manufacturer cannot be held
responsible for damages caused during assembly of the product, for example
scratches or dents.
Spare part list
Information
CAUTION SCISSOR ACTION ! RISK OF INJURY BY CRUSHING! NEVER LEAVE CHILDREN UNATTENDED ! KEEP OUT OF REACH OF CHILDREN !
Assembly instruction
 Ensure that no persons or objects are in the vicinity of
the opening area before opening the sunshade. Do not grasp during opening or
closing between the parts of the frame or the grabpole of the sun shade. Risk
of injury by crushing!
Kink off the parasol carefully!
Open and close carefully!
Do not hang anything on the parasol!
Please close the parasol during strong wind and hard rain!
Please do not use in the near of grills, barbecue, fire, etc!
Important instructions
Delivery without umbrella stand. We recommend using commercially available plastic umbrella stands for filling with sand, water, etc., umbrella stands made from concrete, granite, etc. or for example cross-shaped umbrella stand that you weight down with suitable concrete slabs (40 x 40 cm, 45 x 45 cm, 50 x 50 cm, etc.).
Storage
All sunshade and floor stand components should be stored in a dry and frost- free location during long periods of non-use and over the winter months.
Cleansing
Please use a soft brush and a bit of soapy water to clean the cover fabric.
You can find information about cleaning the canopy material on the label sewed
onto the canopy.
Cleanup the frame components with a mild detergent. Please use only soft,
moist cloth or sponge, no scratching or strong tools, to avoid damages on the
surface.
100 % Polyester (PES)
WATER REPELLENT
Please close the parasol during strong wind and hard rain!
Please do not use in the near of grills, barbecue, fire, etc!
| hand wash
---|---
| Do not bleach!
| Do not tumble dry!
| Do not iron!
| Do not dry clean!
LECO-Werke Lechtreck GmbH & Co. KG – Hollefeldstrasse 41 – 48282 Emsdetten – Germany
| Read assembly manual carefully!|
---|---|---
Important Notes!
All screws, fasteners, fittings, etc. must be checked regularly.
INFORMATION
Read all instructions before assembly and using this product!
- Select ideal location for assembling. Set out all parts on a clear and level surface prior to assembly. Ideally, the product should be set up in the desired location to avoid moving it after assembly.
- Use caution. During all the process of assembling, especially when lifting heavy or large parts, pay attention to safety. No one other than those assistants should be allowed in the work area.
- Check all parts available. Before assembling your product, make sure that you have all parts described in the Parts List.
- Keep children away. Children shouldn’t be allowed in the work area. Do not let them handle parts and tools. Do not allow children to climb on when it is in use.
- It is also recommended to store and secure the products during inclement or stormy weather or remove them completely.
- If after some time using small rust spots occur on your product, that mostly only will be surface rust on parts of steel tubes. This rust can be quickly and easily removed and covered by using some usual paint.
- Carefully remove all packaging material and dispose of it according to type. Should you wish to dispose the product after a long period of use, please observe the local regulations regarding the disposal of the different materials of the product.