AUTEL VCI200 Connection Diagnostics Programing and Relearn User Guide
- June 15, 2024
- AUTEL
Table of Contents
AUTEL VCI200 Connection Diagnostics Programing and Relearn User Guide
QUICKSTARTGUIDE
STEP ONE
Pair the VCI200 with the TBE200, Insert the dongle into the Vehicles
diagnostic port then select the year, make and model from the main menu.
Activate all sensors in the order indicated in the “Check” Function with the
“trigger” button
STEP TWO
After activating each TPMS sensors with the “Trigger” button, tap the
“Diagnostics” tab to perform a TPMS Diagnose. The tool will then compare the
physical location of the sensors and ID’S with the module information.
STEP THREE
After performing the diagnosis, tap the programming tab to create replacement
Autel MX-Sensors. The sensors MUST be programmed prior to installation to
perform correctly. Choose the programming method and place the sensor near the
top of the tool.
STEP FOUR
Tap the relearn tab to execute a tpms relearn. The directions for each
vehicle’s relearn procedure will be provided to minimize errors It there is
more than on method it will be indicated. The TPMS service is now complete!
CONNECTION & PARING OF TBE200
STEP ONE
Verify that both the ITS600 & TBE are connected to the same Wi-Fi network. Tap
the Wear Detection tab. Tap “TBE Click to connect device.” Tap the Device
displayed on the screen to connect the TBE200 to the ITS600
STEP TWO
The 2 tools are now connected successfully. You can now begin tire tread depth
measurements with THE TBE200. The values will be displayed on the ITS600 along
with service recommendations and wear information.
STEP THREE
Tap “Tire Tread” on the TBE200 to begin using measuring tire tread depth. The
values will appear on the ITS600 as well as the TBE200. The tread depth data
will now integrate with the TPMS related information on the ITS600. The data
can be printed and presented on a scan report.
STEP FOUR
The inner middle and outer sections of adjacent tread blocks are measured to
get the most accurate information regarding tread wear. The tool can identify
uneven wear characteristics. Single or All Check Mode can be selected in the
“Check Settings Menu.
PMS VEHICLE HEALTH & TBE200 REPORT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>