AUTEL MaxiSys Elite II Pro Intelligent Diagnostic Tablet User Guide
- October 30, 2023
- AUTEL
Table of Contents
AUTEL MaxiSys Elite II Pro Intelligent Diagnostic Tablet
- Email: sales@autel.com
- Web: www.autel.com
Thank you for purchasing this Autel MaxiSys Elite II Pro. Our tools are manufactured to a high standard and – when used according to these instructions and properly maintained – will provide years of trouble-free performance.
MaxiSys Elite II Pro
- 9.7-inch LED Capacitive Touchscreen
- Ambient Light Sensor – detects ambient brightness
- Microphone
- DC Power Supply Input Port
- HDMI Port
- USB Port
- USB Port
- Power/Lock Button – long press to turn on/off the tablet, or tap to lock the screen
- Speaker
- Collapsible Stand – extends from the back to allow hands-free viewing of the tablet
- Rear Camera
- Camera Flash
- Mini SD Card Slot
- Mini USB Port
- Headphone Jack
Maxi Flash VCI
- USB Port
- DC Power Supply Input Port
- Vehicle Data Connector
- Ethernet Port
- Vehicle LED – flashes green when communicating with the vehicle
- Connection LED – refer to Table 1- 1 Connection LED Description for details
- Power LED – refer to Table 1-2 Power LED Description for details
Table 1-1 Connection LED Description
Table 1-2 Power LED Description
GETTING STARTED
IMPORTANT: Before operating or maintaining this unit, please read these instructions carefully, paying extra attention to the safety warnings and precautions. Use this unit correctly and with care. Failure to do so may cause damage and/or personal injury and will void the product warranty.
WARNING: The MaxiF/ash VG/ is compatible with Autel main cable V2.0 and USB cable V2 only.
- Connect the main cable V2.0 to the Vehicle Data Connector on the VCI unit, and tighten the thumb screws.
- Connect the cable’s 16-pin adapter to the vehicle’s DLC, which is generally located under the vehicle dash.
- Power up the tablet. Ensure the tablet has a charged battery or is connected to the supplied DC power supply.
- Connect the tablet with the VCI via Bluetooth or USB cable. Use only the USB cable connection when programming.
- When the VCI device is properly connected to the vehicle and the tablet, the VCI status button on the bottom toolbar of the screen shows a green badge, indicating the platform is ready to start vehicle diagnosis.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>