Brooklink Electronics Rock Lights and Driver User Manual
- June 6, 2024
- Brooklink Electronics
Table of Contents
Brooklink Electronics Rock Lights and Driver User Manual
Remote Control
App Control
1) APP Download
(1) Scan and download the App “Lumin Shack” in Google Play or App Store
http://fir3.viomesh.com/47ua?utm_source=fir&utm_medium=qr
(2) Waiting for it is successfully installed on your smartphone, click to run it
2) How to use the APP
How to Install Correctly?
Pass the cable through the holster cushion and clamp it in the position shown in the figure.
Install the screws and fix them in the fender of the vehicle (note: y u need to drill holes in the baffle of the vehicle in advance)
If you are not sure how to drill, we suggest going to a professional 4S shuttle a professional install it for you.”
Open the car h d, find the pitied and negative plus of the battery, and
connect the driver device to the corresponding positive and negative poles,
then it can be used normally.
As shown in the figure, follow the position indicated by the arrow and find the precise position to connect, after that tighten the protective sleeve.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>