Nilight JK-52A Rear Bumper Instruction Manual
- June 15, 2024
- Nilight
Table of Contents
Nilight JK-52A Rear Bumper
Installation Instructions
- You are ready to instal the Nligh: Rear Bumper using the following parts:
- Side the lekrackets into the frame and align the mounting holes.
- Now It’s time to bof the bumper up into place, Ideally, a second person would help hold the bumper into plece, Side tre bumper into place, align the holes, and secure it to the frame using the (4) short 18mm bols and corresponding washers provided. Do not fully ighten until the entire assembly is complete.
- Next, irstall the relal mouning plate on the back side of the frame using the (4) long 18mm bolts and the corresponding washers
- Insert he (2) D-Rings if desred.
- Tighten all of the bots and the installation of your Nilight Rear Bumper is complete.
Remove the six mounting bolts from the stock bumper using a 16mm socket. Pull up and out to remove the stock bumper. (Plenty of YouTuBe videos in case you can’t figure it out.)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>