Nilight LED Light Bar 2PCS 18W Spot Led Pods User Manual
- May 15, 2024
- Nilight
Table of Contents
Nilight LED Light Bar 2PCS 18W Spot Led Pods
CONNECTION
Installation
- Connect light bar wires to wiring harness terminals respectively, black to black, red to red.
- Run rocker switch wires through the switch cutout/opening in the dash. Connect the 5-pin rocker switch with the wiring harness. 2 methods of connection, please refer to the instructions on the below page.
- Connect the wiring harness to the car battery. Red wire (+) with fuse to positive, black wire(-) to negative
- Turn on the power and press the switch on/off to test the light.
Caution
- The operating voltage is 12V DC. 16AWG: Max. Wattage 180W/ 14AWG: Max. Wattage 300W/12AWG: Max, Wattage 450W
- Please make sure all the exposed wires are securely wrapped by electrical insulating tape to prevent short circuits.
- Please strictly follow the instructions to avoid any hazards. If you do not feel comfortable with the installtion we recommend having a professional to install or install under his guidance.
Last Step: Complete the 5-Pin Rocker Switch Connection
Note: The above 5-pin rocker switch connection is not completed yet,
please select either one of the following methods to complete it:
PIN-TAB OUTS
-
Upper Light Neg(-)
-
Incoming from the power source
-
Outgoing to relay, accessory or equipment
-
Lower Light Neg. +)
-
Lower Light Pos. (+)
IMPORTANT:
Tape the ends of any unused wire connections to ensure no shorts occur:
Need Help?
If you’re having an issue with the product or need technical support, the Nilight team is always here to help and make sure you 100% satisfied.
Scan the QR code to contact us
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>