Therm TE-02 PRO Reusable Temperature Data Logger User Manual

: June 15, 2024
: Therm

Table of Contents

Product Introductions
Main feature
Quick start
Configuration of a ThermElc TE-02 PRO
Operation Functions
LCD Display Instructions
Battery Replacement
Technical Specifications
Video instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**Therm TE-02 PRO Reusable Temperature Data Logger User Manual

**

Product Introductions

ThermElc TE-02 PRO is used for monitoring temperature of the sensitive goods during storage and transportation. After the recording is finished, the ThermElc TE-02 PRO is connected to any USB port and automatically generates a PDF report with the temperature logging results. No additional software is required to read out the ThermElc TE-02 PRO.

Main feature

Multiple use logger
Auto PDF logger
Auto generate CSV reports
Logging of 32,000 values
Interval of 10 seconds to 18 hours
No special device driver required
MKT alarm and Temperature Alarm

PLEASE NOTE: Technical Specifications Video instructions After the device is configurated for the first time or after re-configuration, please leave the device in an open environment over 30 minutes. This will ensure the device is calibrated with the accurate current temperature.

Quick start

Software Download

https://www.thermelc.com/pages/
download config your paramete

Press start 3 seconds
Measure Monitoring
Read
Report
Helps

Configuration of a ThermElc TE-02 PRO

The device can be configured using the free Data Management software.

Time zone: UTC
Temperature scales: ℃ /℉
Screen display: Always on / Timed
Log interval: 10s to 18 hours
Start delays: 0/ timed
Stop mode: Press button/ disabled
Time format: DD/MM/YY or MM/DD/YY
Start mode : Press button or Timed
Alarm setting: Upper Limit and Lower Limit
Description : Your reference which will appear on the report

Operation Functions

Start Recording
Press and hold the PLAY ( ) button for approximately 3sec.The ‘OK’light is on and the ( ) or ( WAIT ) indicates the logger is started.
Mark
When the device is recording, press and hold the PLAY ( ) button for more than 3sec, and the screen will switch to the ‘MARK’ interface. The number of ‘MARK’ will increase by one, indicating data was marked successfully.
(Note: One record interval can mark one time only, the logger can mark 6 times in one recording trip. Under status of start delay, the mark operation is disabled.)
Stop Recording
Press and hold the STOP ( ) button for more than 3sec until the ‘ALARM’ light is on, and the STOP ( ) symbol displays on the screen, indicating stopping recording successfully. (Note: If the logger is stopped during the status of start delay, a PDF report is generated when inserted into PC but without data.) During normal recording process, shortly press PLAY ( ) to switch to different display interface.
The interfaces shown in sequence are respectively: Real-time Temperature > LOG > MARK > Temperature Upper Limit > Temperature Lower Limit.
Get Report
Connect logger to PC via USB, and it will auto-generate PDF and CSV file.

LCD Display Instructions

| Data logger is recording
---|---
| Data logger has stopped recording
WAIT| Data logger is in Start Delay status
√| Temperature is within the limited range
x and ↑| Measured temperature exceeds its upper limit
x and ↓| Measured temperature exceeds its lower limit