systec therm Tydom Pro Smart Home Box User Manual
- June 4, 2024
- systec therm
Table of Contents
systec therm Tydom Pro Smart Home Box
Tydom Pro
- Ethernet-Anschluss
Installation
Association
- Switch on the installation. Press the receiver button for 3 seconds until its LED flashes. Release.
- Send the association command to the transmitter (refer to the user guide).
- Make sure that the receiver LED is no longer flashing. The products are associated.
Remove an association
- Press and hold for 10 seconds :
- after 3 seconds, the LED flashes slowly.
- after 7 seconds, the LED flashes quickly. Release.
- Confirm on the transmitter (refer to the user guide).
- Make sure that the receiver LED has stopped flashing. The products are no longer associated.
Remove all associations
Hold down the receiver button for 20 seconds. After 3 seconds, the LED flashes slowly. After 7 seconds, the LED flashes quickly. Press and hold the button until the LED goes out. Release
- Pollution level: 2
- Rated impulse withstand voltage: 2.5 kV
- Operation type: S1 continuous duty service S1
- Switch type: 1 single pole
- Number of operating cycles: 100,000
- Circuit cut-off: brownout
References
- Delta Dore : Solutions domotiques pour une Maison connectée
- Elektrowärmetechnik & Komfortlüftung: Systec Therm AG
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>