Cumbor S7V1 Baby Gate Extra Wide User Guide

Cumbor S7V1 Baby Gate Extra Wide

PLEASE READ AND FOLLOW THE INSTRUCTIONS CAREFULLY BEFORE USING.DO NOT cut off the belt before installation is completed! The door gap is NOT a defect! It will be shortened to an appropriate distance as you lock the gate.

Overview

1. STEP1 Measure the width TIP! If you need to place in a doorway that has baseboards, ensure that both the top and bottom measurements are considered.

2. STEP2 Find your size According to the opening size you measured, select the extension you need.
   NOTE : The larger the number of extensions and the wider the expansion, the overall stability strength of the guardrail will be reduced, for your maximum safety, it is recommended to use the hardware installation.

3. STEP3 Install accessories © and 1
   TIP! It’s normal if the jack rotates the bolt loosely, don’t be alarmed.

4. STEP4 Complete the installation

5. .First pull out the two bolts at the bottom of the gate at equal distance and rotate the nut. The direction of the left and right screws rotate inconsistently. Pay attention to the signs on the guard bar.
   NOTE :As you slide and tighten, there will be a” crunch” sound. Don’t be alarmed. it’s normal!

6. Pay attention to adjust the left and right clearance to ensure that the left and right clearance is consistent.

7. If the gate is over-tightened or not tight enough. Adjust clearance of the door gap to 1/16″. In order to tighten the bolts, use a small wrench”F”until the clearance of the door lock fits only one wrench. The distance between the side of the wrench indicates that the installation is completed (positioning column).

INSTALLATION METHOD B

1. Place the position plates on where you want to install the gate. (This is where you will attach the wall cups.)Make sure the plates are centered within your doorway/opening and MARK the position on the wall.
2. Use the wall anchors and the screws to attach the wall cups to the wall, based on your markings.

OPERATION

1. Cut off the belt and test the door gate.
2. When opening the door, it is necessary to pull back the switch above and lift up the guardrail at the same time.
3. Automatic door closing, there will be a click.

TROUBLESHOOTING

1. If the gate does not open or interact properly
   • The gate is over-tightened or not tight enough. Suitable clearance of the door gap is 1/16″. (Please refer to step 4)
   • The latches are not level. Solution: Adjust the tension bolts on each side of the door until it is centered and leveled, with equal distance between the gate and wall on both side, top and bottom.
   • Gate is not properly aligned onto the door frame. Solution: Adjust the gate by loosening all tension bolts and repositioning the gate. Make sure the gate is properly aligned onto the door frame/door opening, then re-tighten tension bolts.
2. If you happen to cut the belt by accident or need to reinstall the gate elsewhere in the future Solution : Use another rope/belt to tie the guardrail before removing, otherwise you may need the assistance of others to help you with installation it.
3. If you need to place it in a doorway that has baseboard: Solution: It will fit securely. Each of the four corners has an adjustable mount that can be tightened to varying distances. Important Advice:Measure the width and ensure that both the top and bottom measurements are considered.
4. If the gate becomes loose on the wall : Solution: Check if the bolts are properly tightened. (Please refer to step 4)

WARNING

• To prevent serious injury or death, securely install gate or enclosure and use according to manufacturer’s instructions.
• Never use with a child able to climb over or dislodge the gate or enclosure.
• This product will not necessarily prevent all accidents.
• Never leave child unattended.
• Use only with the locking mechanism securely engaged.
• Intended for use with children from6 months through 24 months of age.
• Stop using gate if any parts are missing or become damaged.
• Periodically check all fasteners to be sure they are tight and secure.
• Adult Assembly Required.
• The surfaces that the gate is to fixed to must be suitable for the purpose and must be structurally sound.
• Indoor use only, is not to be exposed to outdoor elements.
• Install this gate away from heaters and other sources of heat.
• Children have died or been seriously injured when gates are not securely installed.
• ALWAYS install and use gates as directed using all required parts.
• You MUST install wall cups to keep gate in place. Without wall cups, child can push out and escape.
• NEVER use to keep child away from pool.
• Gates that must be installed at least 4inch from the first step of the stair.

MAINTENANCE

• Clean by using a sponge with warm water or mild detergent. DO NOT use abrasive cleaners or bleach.
• Check the gate regularly to ensure all hardware and mounts are securely tightened.
• DO NOT use if any component is damaged or missing.

Scan the QR code above or search our official account Cumbor Family on YouTube for more detail instruction.

WARRANTY INFORMATION

TWO YEAR NON-TRANSFERRABLE LIMITED WARRANTY

• To provide customers with quality shopping and user experience, we guarantee to replace or issue a refund or provide acceptable solutions to any defective products (as customers prefer) from the date of purchase to 2 years.
• Proof of purchase must be provided (Amazon order number or receipt)when making a claim to our customer support center.
• Warranty registration may be requested within a month since the date of purchase, by sending your Amazon order number to the mailbox: support@aborderproducts.com
• The warranty is not transferable. We only provide warranty services for buyers purchased from our Amazon store and the recipients possessed the purchase proof, and not any other purchaser or subsequent owner.
• Price matching policy is not applicable. No price difference refund.
• Sellers are the responsible party. Amazon allows different sellers to sell the same product, so please confirm the seller by checking the order details before contacting us.

WHAT IS COVERED

1. Received defective or used (proof needed) products;
2. Received with missing parts;
3. Defective item under proper use.

WHAT IS NOT COVERED

1. Purchased from non-Amazon channel or other physical stores;
2. Gift without proof of purchase;
3. Tampering/abnormal use/accidental damage;
4. Replacements and parts;
5. Installation fee/labor fee.

MAKING A CLAIM
If you have any problems when using our products, you can choose any of the methods to reach out to us.

Manufacturer Support

• 1-888-281-8150 (24/7)
• support@aborderproducts.com(24/7)
• Have a question for the seller
• 30. 30 Days Free Return & Replacement
• 2-Year Product Warranty

Have a question for the seller?

1. Find your order
2. Click “View order details”
3. Click the “Seller name”
4. Click “Ask a question”

Gifted parts, replacements, consumable products are not covered by the 2-year warranty .Manufacturers’ warranties may not apply in all cases, depending on factors such as use of the product, where the product was purchased, or who you purchased the product from .Please review the warranty carefully, and contact the manufacturer if you have any questions.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>