UBIQUITI SWX-WAVEPRO AC PRO Wireless Access Point User Guide
- June 14, 2024
- UBIQUITI
Table of Contents
UBIQUITI SWX-WAVEPRO AC PRO Wireless Access Point User Guide
INSTRUCTION
FCC ID: SWX-WAVEPRO IC ID : 6545A-WAVEPRO
Ubiquiti Inc. will be incorporating the E-Label procedures per FCC KDB 784748-D02. The information below is what will be included in the E-Labeling.
E-label and warning statements can be found in the device/controller GUI under Device > Settings > About.
Detailed compliance information including Declaration of Conformity is available at the following internet address: ui.com/compliance
NOTE
This outdoor access point operating in the U-NII-1 band the maximum e.i.r.p. at any elevation angle above 30 degrees must not exceed 125 mW (21 dBm)
FCC
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generated, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user bill be required to correct the interference at his own expense.
ISED Canada
CAN ICES-3 (A) / NMB-3 (A)
This device complies with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Warning
The antennas used for this transmitter must be installed to provide a separation distance of at least 400 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>