ELVITA EIE300S In Ear Headphones User Manual

: June 14, 2024
: ELVITA

Table of Contents

OVERVIEW
SAFETY
USING EARBUDS
TROUBLESHOOTING
Problem with sound transmission
TECHNICAL SPECIFICATIONS
EU Declaration of conformity
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ELVITA EIE300S In Ear Headphones User Manual

OVERVIEW

A. Decrease volume
B. Backward
C. Voice assistant (Siri, Google etc)
D. Answer a call (L or R)
E. Reject a call (L or R)
F. End a call (L or R)
G. Play/pause (L or R)
H. ANC/ambient/normal (touch x3 to cycle through the modes)
I. Increase volume
J. Forward
K. Charging case
L. Charging port
M. Case button (reset, BT pairing)
N. Eartips (small, large)
O. USB-C charging cable

SAFETY

Carefully read the instructions before you install and use the product. Save the instructions and
keep them near the product for future reference. All kinds of warranties shall be invalid if these instructions are not followed.

The model code is printed on the product.

DANGER!

This product contains a lithium battery. If misused, opened or damaged, it can become a hazard and may explode.
Do not attempt to burn the earbuds. The battery could explode causing injury and death.

WARNING!

Do not attempt to open, modify, disassemble, repair or in other way access the internal structure of the earbuds. They are not user serviceable.
The product contains small parts and are not suitable for children 3 years old and below.
Do not use your earbuds in the immediate proximity (10 cm) of a pacemaker.
Do not subject the earbuds and included accessories to abnormal wear and tear.
Always use a standard charger.

WARNING!

Do not expose the product to liquids, moisture or humidity. It has electronics and a battery in it.
Do not use abrasive cleaning solvents to clean your product. Wipe them down with a slightly damp cloth if and when necessary.
Remove and clean the earbuds tips regularly, to ensure the best sound possible.
Do not expose product to extremely high or low temperatures as this may damage the battery or even deform the plastic parts.
Do not drop your product. Keep it away from sharp objects such as keys in your pockets.
Only charge your product from 5V USB ports such as phone chargers and laptops or PCs.
Never listen to music at high volumes or you may permanently damage your hearing.
Do not use earbuds while driving, riding or walking through traffic areas

CAUTION!

Any changes or modifications to this product not explicitly approved by the manufacturer could void your authority to operate the equipment.

NOTE!

For the best possible experience, always use the product as described by the manufacturer.

Disposal

DANGER!

This product contains a lithium-ion battery. If misused, opened or damaged, it can become a hazard and may explode.

WARNING!

Dispose of the used battery according to your local waste disposal authority.

The European Directive for batteries 2006/66/EC states that it is not permitted to throw away batteries with household waste. They may contain substances which are harmful to the environment. Empty batteries can be handed over to local, public collection point or a local recycling center.

Dispose of packaging in an environmentally-friendly manner. Recycling packaging, while observing national and local regulations, can reduce the consumption of raw materials and the amount of waste in landfill sites.

This product complies with international directives, including but not limited to WEEE

Directive (2012/19/EU). The symbol on the product or on its packaging indicates that this product should not be treated as household waste. Consult your local waste disposal authority for guidance on how to properly recycle or dispose of this product.

By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact the relevant municipal body in charge of waste management, your household waste disposal service or the store where you purchased the product.

USING EARBUDS

Pair earbuds with device

Turn on the Bluetooth on your device.
Open the charging case
Press and hold the case button for 5 seconds until the green light of the charging case flashes twice slowly. The earbuds disconnect from any earlier connection and enter pairing mode. The red light is lit for 2 seconds.
In pairing mode, the main earbud lights flash red and blue, while the secondary earbud lights flash blue every 5 seconds.
NOTE! When the earbuds have not already been paired with a device, they will automatically enter pairing mode.
Go to Bluetooth settings on your device and select EIE300S to pair with your earbuds.
When the pairing is completed, an acoustic signal sounds and the blue light is lit for 3
seconds. While connected, the blue light flashes every 20 seconds when no music is
playing. If the pairing fails, a red light is lit and the earbuds stay in pairing mode for 5 minutes and then turn off.

NOTE!

Until unpaired, the earbuds automatically connect with the paired device each time they are powered on.
If the main and secondary earbuds are not connected with each other, they function as individual headsets, with red and blue flashing alternately on both earbuds.
After losing connection due to being too far away, an acoustic signal sounds and the
earbuds enters reconnection mode. In reconnection mode, the main earbud flashes twice every 5 seconds, and the secondary earbud flashes once every 5 seconds.

Turn on earbuds

Open the charging case.
Take out the earbuds from the charging case and put them in your ears.
The earbuds are automatically turned on, and an acoustic signal sounds.
If the earbuds do not turn on automatically, manually turn them on by touching both the left and right earbuds for 3 seconds.

NOTE!

ANC (Active Noise Cancellation) mode is on by default when turning on the earbuds.
Charge the charging case if the case is open but the earbuds do not turn on.

Turn off earbuds

Place the earbuds in the charging case.
Close the charging case.
An acoustic signal sounds and the earbuds are automatically turned off.

Charge earbuds

A low battery level of the earbuds is indicated by a red light that flashes 3 times when the case is opened.
A battery level less than 20 % is indicated by an acoustic signal that sounds twice every 10 minutes and a red light that flashes before the earbuds turn off.
A 30 % – 100 % battery level is indicated by a blue light that flashes 3 times when the charging case lid is opened.

Place the earbuds in the charging case.
The earbuds’ red light is lit.
When the earbuds are fully charged, the red light turns off

Charge case

A low battery level, less than 30%, in the charging case is indicated by a steady red light.
A battery level greater than 30% is indicated by a steady blue light.
A full battery level is indicated by a steady green light for 2 minutes.

Place the earbuds in the charging case.
Plug in the USB type-C to start charging the case.
When the case is fully charged, the green light on the charging case is lit. The green light turns off when the charging cord is removed.

Reset earbuds

Reset the earbuds if only one earbud connects to the phone and the earbuds can not pair together.

Place the earbuds in the charging case and leave it open.
Press and hold the case button for 10 seconds.
The green light of the charging case flashes three times.
The right light of the earbuds flashes twice slowly and a blue light is lit.
The earbuds are reset and the green light of the charging case is lit for 2 seconds.

TROUBLESHOOTING

Problem pairing and connecting

Make sure the earbuds are not connected to another device.
Disable and enable Bluetooth on your device.
Move the earbuds closer to the device or alter their positions to avoid Bluetooth interference.
Verify that no other wireless equipment interfere with your earbuds Bluetooth signal.
If the earbuds do not pair with each other, place the earbuds in the charging case, close the lid and open again. Then take them out both simultaneously.
After losing connection due to being too far away, an acoustic signal sounds and the earbuds enters reconnection mode. In reconnection mode, the main earbud flashes twice every 5 seconds, and the secondary earbud flashes once every 5 seconds.

Problem with sound transmission

Move the streaming device to another position. Your body, distance, different materials and other wireless equipment can interfere with the wireless signal between your device and earbuds.

TECHNICAL SPECIFICATIONS

Driver: Ø 10 mm
Support profile: HFP / AVRCP / A2DP
Bluetooth: 2.402-2.480 GHz
Transmit power: 9 dBm
Earbuds charging time: Up to 1.5 hour
Case charging time: Up to 1.5 hour
Working voltage: 5 V
Transmission range: Max 10 m
Working temperature: -5 °C to 50 °C
Bluetooth version: 5.2
Hybrid ANC : ≥ 30 dB
MIC: 2*2
Input: DC5 V – 1 A
Impedance: 16 Ω
Frequency response: 20 Hz-20 kHz
Sensivity: 110 dB
Output: 4 MW
SNR: ≤85 dB
Total playtime: 25 h
Earbud battery: 3,7 V/40 mAh (each)
Charging case battery: 3,7 V/400 mAh
IPX certification : IPX4

EU Declaration of conformity

This product fulfils the essential requirements and other relevant provisions of Directive 2014/53/EU and all other EU directive requirements and carries the CE mark. If not included with the product, a copy of the EU Declaration of Conformity is available on request.
This product has been evaluated to meet general RF exposure requirement. It can be used in portable exposure condition without restriction.

Evita products are distributed and marketed by Elon Group AB.
Elon Group AB Bäcklundavägen 1 | 702 03 Orebro Sweden
ELON GROUP | +46(0)10-220 40 00 | ELONGROUP.SE
Support and service: ELVITA.SE

Thank you

for your trust and the purchase of our product. Make sure you have received an undamaged
product. If you do find transport damage, please contact the seller from which you purchased the product, or the regional warehouse from which it was supplied.