PHYSEN Wireless Doorbell with 2 Receivers User Manual
- June 14, 2024
- PHYSEN
Table of Contents
Wireless Doorbell with 2 Receivers
Wireless Doorbell
X2 Series User Manual
Please read this user manual before using and installation.
Product Introduction
Our new wireless doorbell use advanced
technology to make sure detection signals
more accurate. We dedicates to improve
your living quality and simplify your lifestyle
as envelopment direction, and we have been
committed to researching and developing
more high quality and competitive products.
Package
Plug-in Receiver
Transmitter Button(Battery Included)
Setup Toolkit
User Manual
Technical Specification
Receiver working voltage AC100V-240V
Sound pressure level 0-110 dB
Receiver consumption AC power < 0.25 W (standby mode)
Working frequency 433.92 MHz
Wireless Working Range 1,000 ft (in open range)
Transmitter battery type A23 12V Alkaline Battery
Features
- 58 melodies optional
- 2. 5 level adjustable volume (mute mode with light only)
- 1,000 FT wireless distance range
- Water-proof transmitter
- Memory function, keep the previous settled tune after re-plugging it
- Easy to set up, adhere with double-sided tape or screws-in
Getting Started
-
INDOOR CHIME RECEIVER
Plug the receiver into the outlet and press
to test whether it can make sound.
The receiver will perform better if kept
away from other electrical equipment. -
DOORBELL TRANSMITTER
Peel off the insulating film, push the
button to trigger the receiver to ring. -
SOUND VOLUME CONTROL
Press the on the receiver to cycle
through 5 volume levels. -
CHOOSE THE RINGTONE
Press or to choose your favorite ringtone.
Operating Instructions
1. PAIRING THE DOORBELL
(1)Short press or to select one tone
(2)Long Press for 5 seconds (or Short Press and together), the receiver beeps
once and flashes once, it’s on pairing mode.
(3)Trigger the button, doorbell receiver rings and flash’s, it is done.
2. ADD MORE TRANSMITTERS AND RECEIVER
If you would like to add more transmitters
and receivers, please repeat the STEP 1
for every transmitter and receiver.
3. RESET
Long press for 5 seconds to reset
receivers to default, the receiver beeps
once and flashes once that means the
reset was successful. Then you can follow
the STEP 1 to re-pair again.
Note: Pairing mode will quit
automatically after paring is
completed or No response
for 5 seconds.
Installation
Troubleshooting
| Problem | Cause | Solution |
|---|
Indicator of
the button
does NOT
light up
| Insulating film has
not been peeled off|
Peel off the insulating
film
The battery is not
properly installed|
Take out the battery
and install it again.
Make sure the contacts
are good.
The battery power
is low|
Replace with new
battery
The receiver
does not
respond to the
transmitter| Unsuccessful
pairing|
Pair the transmitter and
receiver again
The receiver
only lights
but NO sound| Mute mode is ON|
Push the to make a sound
WARRANTY AND AFTER-SALE SERVICE
There is 18 months warranty for our product.
If you have any using question of product,
please do not hesitate to contact us through
cgd-us@outlook.com, our 24-hour email
standby.