oneisall DTJ-001 Pet Grooming Clipper User Manual
- June 14, 2024
- Oneisall
Table of Contents
- oneisall DTJ-001 Pet Grooming Clipper
- Part name
- Accessory name
- Charging/Plugging
- Charging instructions
- Cutter head disassemble
- Cutter head installation
- Cutter head clean
- Product Specification
- After-sales Service
- LED Screen Display
- How to use
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
oneisall DTJ-001 Pet Grooming Clipper
User Manual
Any problems you have, please contact us:
support@oneisall.com
Part name
Accessory name
Charging/Plugging
- Confirm that the machine is turned off, and plug the USB cable into the 5V1A adapter (desktop/mobile power supply and other power supplies with USB interface) to charge the charging indicator flashes.
- The display screen will show the charging status. After full charge, pull out the charging cable.
Charging instructions
-
Please charge the pet clipper for 3 hours the first time use. After 3 to 4 times of full charge and discharge, the battery capacity will reach the best state.
-
The best ambient temperature for charging is between 5°C and 40°C
NOTE- Pet hair clipper wireless use.
- In the case of no power, the pet hair clipper can be connected directly to the charger for cable operation.
-
Install the guide comb as your needs
Cutter head disassemble
Trun off the switch, press the cutter head with your thumb, and push it out in the direction as pic.
NOTE
To avoid the cutter head falling, please hold the cutter head during
disassembly
Cutter head installation
Put the cutter head connection A into the body clamp slot B
After aligning, press the cutter head back firmly until you hear a “click”
Cutter head clean
Use a cleaning brush to remove the hair crumbs stuck on the cutter head
Clean the hair chips stuck between the upper and lower blade gaps
Cutter head maintenance:
Apply 1-2 drops of lubricant oil into the 5 positions of the cutter head as
shown Fig.
After dripping oil, press and hold the movable tool holder to move back and forth to make the lubricating oil evenly lubricate the tool head.
Product Specification
After-sales Service
LED Screen Display
- Battery percentage display(1%-100%)
- 1 Speed 5500rpm white light is on
- 2 Speed 7000rpm orange light is on
When orange light is on means you need dripping oil, the light will flash 15 seconds
How to use
Any problems you have, please contact us : support@oneisall.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>